ARM system development tutorial

应用背景ADI的DDS芯片AD9834，可以进行扫频，点频程序，实现频率的输出，可以修改后，运用到DSP/ARM等嵌入式芯片中。关键技术兼具点频模式和频率扫描模式;上位机选择工作方式;输入数值，单位：Hz;单片机串口工作方式1，波特率9600

用AT91RM9200控制信利的LCD，在ADS下实现的测试程序，方便初学者使用。-AT91RM9200 with the benefit of controlling the LCD, the ADS under the testing procedures facilitate beginners.

TMS320F2812 FFT 源代码 -TMS320F2812 FFT source code

基于ARM和CPLD的氢气参数实时监测系统-ARM-based CPLD hydrogen parameters and real-time monitoring system

周立功ZLG_LPC213X的全套资料，这个是其中的SSP-Week Ligong ZLG_LPC213X a complete set of information, this is one of the SSP

基于S3C2440，一个LED灯的驱动程序。-Based on S3C2440, an LED lamp driver.

his project was built and tested with WinAVR-20060125. Make sure the MCU target define in the Makefiles corresponds to the AVR you are using!! To build the code, just install WinAVR and run "make" from the console in echomaster and echoslave subdirs. "make program" will program the device if you have a AVRISP attached. Remember to set the AVR device to at least 8MHz. The AVR may use the programmable clock from MC1319x, just remember to check if the MC1319x and SPI communication is working FIRST! Otherwise you wont get any clock signal to the AVR and then you can t program it or reset the fuses! The MC1319x has default clock output of 32kHz so you will have to set your programmer to a very low frequency (

GTM900-ARM(LPC2104)-LWIP1.1拨号详细介绍及源码。-GTM900-ARM (LPC2104)-LWIP1.1 dial-up detail and source code.

at91sam9268-linux 驱动程序 tlv320aic23 驱动程序 这是简单的驱动 ssc 总线用于数据通信胳膊到编码解码器

用单片机为电饭锅做“手术”。 汇编文件，带dsn 仿真-For the rice cooker to do with single-chip " operation."