此为友善之臂micro2440板的底板原理图，更新时间是2009年2月28日。...

FIQ有FIQ_PWM、FIQ_TMA和FIQ_TMB三个中断源,当定时器A或B计满溢出时产生中断请求信号TA_TIMEOUT_INT或TA_TIMEOUT_INT,CPU响应后进入中断执行相应的子程序控制二极管发光。A口的低四位接LED灯，B口的低四位接LED灯.-FIQ has FIQ_PWM, FIQ_TMA and FIQ_TMB three interrupt sources, when the timer A or B when the expiration overflow interrupt request signal TA_TIMEOUT_INT or TA_TIMEOUT_INT, CPU response after interruption of the implementation of the corresponding subprogram control light-emitting diodes. A low population of four LED lights then, B I take the low four LED lights.

开机自启动程序，很好很强大的。每次开机都能自己启动此程序。-Boot from the startup procedure, very good very strong. Each boot can start this process themselves.

LT-1B msp430开发板例子程序－ADC12_09

本设计采用凌阳16 位单片机SPCE061A对步00进电机进行控制，通过IO口输出的具有时序的方波作为步进电机的控制信号，信号经过芯片L298N驱动步进电机；-This design uses 16-bit single-chip Sunplus SPCE061A to step into the motor control 00, through the IO port with the output timing of the square wave as a stepper motor control signal, the signal after the chip stepper motor driver L298N

离散 PID 控制 设计方法 ATMEL参考设计-PID control design method of discrete reference design ATMEL

用0832做的波形发生器 做信号的可以看看 用单片机控制的-0832

USB开发D12的结构-USB D12 structure

由AT98C51单片机硬件电路,用C51编写的红外线解码程序. -AT98C51 single-chip hardware circuit by using C51 decoding procedures for the preparation of infra-red.

一种无线传感器网络CSMA协议的设计与实现-csma

单片机中用于相位差测量仪的c程序，开发环境是Iar。主要运用于430 单片机-Single-chip in for the c phase difference measurement procedures, the development environment is Iar. The main application of 430 single-chip microcomputer