液晶TS1620的程序

mcf5272的裸奔程序，初始化mcf5272，建立C环境，跑例子程序。-mcf5272 the streaking procedure, initialize mcf5272, the establishment of C environment, run an example program.

This file contains the following sections: 1. Code Example Description 2. Folder Contents 3. Suggested Development Resources 4. Reconfiguring the project for a different PIC18F device 5. Revision History

采用proteus实现无刷直流电机控制的仿真分析，驱动电路由ir2101和MOSFET管组成，主控芯片选用51单片机，keil编程实现，系统为开环控制方式。

2410的原理图整理，已经是原理图SCH文件，原理已验证通过，现在就是PCB还没制作完成-2410 schematic diagram of the sorting is already SCH schematic document, the principle has been verified through, now is not yet finished PCB

嵌入式系统中的数码管显示-Embedded System digital Display

linux下，与s3c2410连接的前端衰减器pe4302驱动程序，用于控制模拟信号的衰减量。-linux with S3C2410 connect the front-end attenuator pe4302 drivers, analog signal used to control the attenuation.

MSP430G2553LaunchPad 12864显示其DCO频率 使用LaunchPad上提供的32768晶振计数 12864采用SPI通信，代码使用了软件模拟的SPI 需要使用带汉字字库的12864

是modbus的C写的源代码,可移植到任意的芯片.该代码用在freescale 芯片.用的是大端模式.如果到小端模式的芯片需要稍微修改一下.-Is the modbus source code written in C, portable to any chips. The code used in the freescale chips. Using a big endian mode. If the little-endian mode of the chip need to be slightly reformulated.

登陆注册登陆注注册注册注册注册注册注册注册注册

Windows嵌入式开发系列课程(6)：启动程序BootLoader的分析 _PDF.zip-Windows Embedded Development Series courses (6): start a program BootLoader analysis _PDF.zip