用C语言写的HT1621的驱动程序，非常好的实例。-C language to write the HT1621 the driver, a very good example.

无线传感器网络低占空比MAC协议研究 介绍MAC协议-mac protocol

51控制STA013实现MP3音频解码，实现了STA013的初始化、音量调节、静音、音质设置、声道控制。同时包含通过RS232串口控制LCD实现同步显示。代码经过调试，运行通过。

在单片机向实际系统发出控制信号时,需用数模转换芯片将数字信号转成模拟信号.这个程序和原理图详细说明了DA转换器的应用和开发.-In SCM systems to the actual control signal, the required digital-to-analog converter chip digital signal into analog signal. This procedure and schematic diagram detailing the application of DA converters and development.

温度控制器V1.5 显示为三个共阳极LED 温度传感器用单总线DS18B20 CPU为2051，四个按键，分别为UP，DOWN，SET 温度调节上限为125度，下限为-55度 只能用于单只18B20-Temperature Controller V1.5 show for a total of three LED anode temperature sensor with single CPU for the bus DS18B20 2051, four keys, respectively UP, DOWN, SET temperature regulator ceiling of 125 degrees and lower limits of-55 degrees can only be used solely 18B20

此程序是有关红外的程序 mcu用啊他89c52 采用外部中断0接一体化红外接受头038 （就是影碟机上拆得的） P0 P2接数码管 P0数据 P2位选 能显示遥控器的系统码及其反码 数据及其反码 （共8位） 实际调试成功 工作稳定 测试红外发光二极管的方法 用2v电源 接红外发光二极管 在摄像头下能看到淡紫偏白的光-This procedure is related to the procedure infrared mcu ah him with 89c52 using external interrupt 0 then the integration of infrared to accept the first 038 (that is player on the demolition of a) P0 P2 then P2 digital tube P0 data bit selection can display the remote control system code and its anti-code data and the anti-code (a total of eight) the actual success of the work of debugging and stability testing of the method of infrared light-emitting diodes with 2v power then infrared light-emitting diode in the camera can see under the white light side lilacinus

基于MAX6675的温度测试及在液晶显示程序 -MAX6675 temperature-based testing and procedures in the liquid crystal display

此源码利用单片机模拟实现IIC总线通信，可以连接基于I2C的硬件调试 -use of this source SCM simulation IIC bus communication, based on the I2C can be connected to the hardware debugging

ds18b20的程序，经过测试可以使用分享一下-DS18B20 procedures tested can use to share

凌阳16位机 SPL501驱动程序－显示字符-Sunplus 16-bit machine SPL501 driver- display characters