四路MPEG1视频采集卡，DDB文件 附原理图 PCB图纸

在PXA270主板上，配置完基本的GPIO后，可以用本程序读写CF卡来测试CF插槽的硬件连线-The motherboard in PXA270, finished basic GPIO configuration, you can use this program to read and write CF slot CF card to test the hardware connection

Smart Card Reader Interfacing with 8051 and small application.

定时器的应用 本程序简单的示范了如何使用ATMEGA16的定时器 AVR定时器的要点介绍 T0工作于CTC模式，输出1KHz/2KHz 50％占空比的方波 T1工作于快速PWM模式兼输入捕捉 T2工作于相位修正PWM模式，输出490Hz的8bit PWM波 -Application Timer simple demonstration of this procedure how to use the ATmega16 timers AVR timer T0 introduce the main points of work in CTC mode, the output 1KHz/2KHz 50 duty cycle square wave T1 work in fast PWM mode Input Capture and T2 work on phase-corrected PWM mode, the output of 8bit PWM wave 490Hz

minigui listview 源代码，主要是ubuntu下的minigui关于列表的源代码。-minigui listview source code, mainly minigui under ubuntu source code on the list.

它是用来表示在图形液晶屏上，将监测速度、 方向和 lattitude 和 longuitudes 的 gps 参数代码

嵌入式开发介绍，方便初次接触嵌入式linux开发的人员学习。-Embedded Development Introduction to facilitate the initial contact with the embedded linux development of staff learning.

利用ARM2103编写的实时时钟程序，请各位高手指点-ARM2103 prepared to use real-time clock procedures, expert advice please

一个非常好的嵌入式串口读程序，思路清晰，值得一看-A very good read embedded serial procedures, clear lines of thought, see

一个嵌入式linux的驱动程序例子，包含了McBSP的DSP启动例子-An embedded linux driver example, contains examples start McBSP of the DSP

汇编源代码大全4--Assembly source code-4.