这个是用来控制以ssd0323为主控芯片的显示屏的程序。在这个程序是以串行接口控制屏的...

CAN总线原理和应用系统设计-邬宽明 网评很好的一本书，电子版的很难找，CAN总线开发的经典教科书-Principle and Application of CAN Bus System Design- Wu Kuan-ming network assessment a very good book, the electronic version of the hard to find, CAN Bus development of the classic textbook

此程序为一排队机呼叫器,主要功能是：用键盘控制液晶显示实现485通讯,具体协议可参考《排队机通讯协议050609.doc》.编译环境为ICC-AVR6.3,采用了ATmega8芯片,晶振速率为6.0000Mhz-Queue for a beeper, the main function is : keyboard control LCD achieve 485 newsletters, reference specific agreement "Queue 050609.doc communication protocol." Build environment for the ICC-AVR6.3 using the ATmega8 chips, crystal rate of 6. 0000Mhz

一个可以跑RTOS(KEIL) FULL的补丁。-can run a RTOS (KEIL) FULL patch.

c51 使用技巧 很不容易得到了 c51 使用技巧 很不容易得到了-C51 skill

AVR mage8单片机的bootload程序、完整版本、本人做项目一下在用、此程序为16m晶振版本、非常好用-MCU AVR mage8 Bootload procedures, full version, I do projects like the use of this procedure for the 16m crystal version, very easy to use

内容：1、本程序用于测试4相步进电机常规驱动 2、需要用跳帽或者杜邦线把信号输出端和对应的步进电机信号输入端连接起来 3、速度不可以调节的过快，不然就没有力矩转动了 4、按s4（设置成独立按键模式）可以控制正反转 -Contents: 1, the procedure used to test the four-phase stepper motor-driven two conventional, need to jump cap or the signal output line of DuPont and the corresponding stepper motor signal input terminal connected three speed adjustment can not be too fast, Otherwise, there would be no moment of rotation of the four, according to s4 (set to form an independent key mode) can control the positive inversion

pcf8563实时时钟芯片与spec061单片机接口的测试程序,并使用了LCD显示,测试通过.-pcf8563 real-time clock chip microcontroller interface spec061 testing procedures, and the use of the LCD display, the test.

该算法为基于PD增益自适应调节的PID控制 用MATlab开发，能够管直接运行-The algorithm for the adaptive gain based on the PD of the PID control Matlab development, be able to pipe directly to run

DS18B20程序(LJD-SY-5100单片机程序) 控制DS18B20完成芯片的控制和数据传输-DS18B20 procedures (LJD-SY-5100 single-chip process) control chip DS18B20 complete control and data transmission

电平转换芯片资料，串口与单片机通讯应用，转换后电压在0-5之间-Chip-level conversion data, with the single-chip serial communications applications, the conversion after the voltage is between 0-5