登录
首页 » SCM » LTC1446是一种采用12位逐次逼近式工作的A/D转换器。内部包含系统时钟、采样和保持、12位A/D转换器、数据寄存器以及控制逻辑电路。LTC1446每25u...

LTC1446是一种采用12位逐次逼近式工作的A/D转换器。内部包含系统时钟、采样和保持、12位A/D转换器、数据寄存器以及控制逻辑电路。LTC1446每25u...

于 2022-04-16 发布 文件大小:850.00 B
0 183
下载积分: 2 下载次数: 1

代码说明:

LTC1446是一种采用12位逐次逼近式工作的A/D转换器。内部包含系统时钟、采样和保持、12位A/D转换器、数据寄存器以及控制逻辑电路。LTC1446每25uS重复一次“输入――转换――输出”。器件有两个控制输入:DIN CLK和片选(CS)。 内部系统时钟和DIN CLK可独立使用。应用电路的设计只需利用时钟启动转换或读出转换结果。当CS为高电平时, Dout处于高阻态且DIN时钟被禁止。

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • 单片机汇编快速入门助手 ,适用单片机初学者使用
    单片机汇编快速入门助手 ,适用单片机初学者使用-MCU Series Quick Start aide, apply SCM beginners
    2022-11-14 20:05:04下载
    积分:1
  • 这个是和电脑接口的51单片机数据采集的 硬件系统
    这个是和电脑接口的51单片机数据采集的 硬件系统-This is a computer interface and the 51 single-chip data acquisition hardware system
    2023-04-25 21:45:04下载
    积分:1
  • TFT LCD screen test procedures, CPU W77E58 to amend the directive to be sent on...
    TFT液晶屏测试程序,CPU为W77E58,修改发送指令可在液晶屏上显示不同的字符或图形-TFT LCD screen test procedures, CPU W77E58 to amend the directive to be sent on LCD screen show different characters or graphics
    2022-06-01 03:08:50下载
    积分:1
  • This is a microcontroller serial communication to achieve a simple example
    这是一个实现单片机串口通讯的简单例子,对初学者是很有用的-This is a microcontroller serial communication to achieve a simple example
    2022-01-25 23:29:12下载
    积分:1
  • 单片机实现DES的程序包
    单片机实现DES的程序包-DES realize single-chip package
    2022-04-11 06:51:40下载
    积分:1
  • xc164cs_adc xc164cs的AD转换程序
    xc164cs_adc xc164cs的AD转换程序-xc164cs_adcxc164cs the AD conversion process
    2023-03-06 21:05:04下载
    积分:1
  • 这个程序可以使用fpga上的晶振,用于测试晶振得使用
    这个程序可以使用fpga上的晶振,用于测试晶振得使用-This process can use the FPGA on the crystal, crystal was used for testing
    2022-02-02 17:44:14下载
    积分:1
  • 《模拟I2C总线多主通信的通用软件包》,支持多主竞争,比如有多个单片机和I2C器件同时工作。...
    《模拟I2C总线多主通信的通用软件包》,支持多主竞争,比如有多个单片机和I2C器件同时工作。- Simulation of multi-master I2C bus communications generic package to support multi-master competition, for example, has a number of SCM and I2C devices work at the same time.
    2022-02-10 11:09:58下载
    积分:1
  • keilc+ proteus light parallel port design of experiments requirements: master th...
    keilc + proteus 并行口设计指示灯实验 要求:掌握80C51单片机输入输出接口使用方法 学会开关量输入输出控制的接口技术及编程方法 实验题目:8个发光二极管D1~D8分别接在单片机P1.0-P1.7端口上,一个开关接在P3.0上。要求输出端口输出 “0”时,发光二极管亮。开关闭合时,开始按P1.0-P1.1-...-P1.7的顺序依次点亮LED,再按 P1.7-P1.6 -...-P1.0的顺序点亮LED,重复循环。开关断开时,立刻停止点亮指示灯。-keilc+ proteus light parallel port design of experiments requirements: master the 80C51 microcontroller input and output interfaces Society of switch to use the amount of input and output control interface technology and programming methods Experimental subjects: eight light-emitting diodes D1 ~ D8, respectively connected to the MCU P1.0-P1 .7 port on a switch connected to the P3.0 on. Requested output port output " 0" , the light-emitting diode light. Is closed, to embark on the P1.0-P1.1-...- P1.7 in the order light LED, and then P1.7-P1.6-...- P1.0 order light LED Repeat cycle. Switch off when the stop light indicator.
    2022-11-16 18:10:03下载
    积分:1
  • 这是通信接口实验,";DA转换原理的表达。
    这是通讯接口实验《DA转换原理实验》的原理程序,适合于那些上嵌入式系统、通信、计算机专业的人-This is the communication interface experiment, "DA conversion principle experiment," the principle procedures, suitable for those on embedded systems, communications, computer specialists in the
    2022-05-27 10:56:56下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载