这是用asm编写的加法程序，是用16位的凌阳单片机汇编

本系统参照片上系统的设计架构、采用FPGA与SPCE061A相结合的方法，以SPCE061A单片机为进程控制和任务调度核心；FPGA做为外围扩展，内部自建系统总线，地址译码采用全译码方式。FPGA内部建有DDS控制器，单片机通过系统总线向规定的存储单元中送入正弦表；然后DDS控制器以设定的频率，自动循环扫描，生成高精度，高稳定的5Hz基准测量信号。-The system with reference to the design of system-on-chip architecture, used a combination of FPGA and SPCE061A approach to SPCE061A Singlechip for process control and scheduling core mission FPGA for external expansion, internal self-system bus, address decoding using the entire translated code approach. DDS has built internal FPGA controller, microcontroller through the system bus to the provisions of the storage unit into the sine table DDS controller and then to set the frequency, automatic cycle of scanning, to generate high precision and high stability of the baseline measurement 5Hz signal.

430的SD16模块扩展到20bit采样精度的范例-430 extended to the SD16 module 20bit sampling accuracy of the sample

atmel89c51cc03单片机的can通信，调试通过-atmel89c51cc03 SCM can communication, debugging through

C51 TIMER 0的使用 Timer_0_mode_1_counter_gate_hard-C51 TIMER 0 use Timer_0_mode_1_counter_gate_hard

c8051f021单片机资料-c8051f021

330PWM输出的简易程序，供C8051F330的初学者参考

这是一个MSC51单片机程序它读出片外RAM中的数据从串行口发向机-This is a procedure MSC51 SCM read it out off-chip RAM data from the serial port to the machine

编译通过的两块单片机读写双口RAM7132的原程序！供大家参考！-compiled by the two dual-port MCU literacy RAM7132 the original program! For your reference!

万年历挂钟智能系统设计开发环境为ICC,可以编译成汇编,直接下栽到嵌入式avr单片机进行控制-calendar wall clock intelligent system design and development environment for the ICC, can compile a compendium, Embedded directly to the downward avr microprocessor control

pc机连接单片机-pc linked MCU