系统以AT89S52单片机为控制核心，加以直流电机、舵机、光电传感器、火焰传感器和电源电路以及其他电路构成，设计报告完整，元器件选择比较恰当，制作的小车能完成题...

这是52单片机串口调试程序，通过此程序，可以使单片机于PC机通信-This is the 52 single-chip serial debugging process, through this program will enable single-chip communication to the PC

demo程序及开发板-demo procedures and development board

8051C thorough application of the language (book)很有用的软件。-8051C thorough application of the language (book) very useful software.

单片机c语言教程 呵呵 早就下的了 不错了-SCM c language tutorial He He already has pretty good under the

LCD1602的显示程序，用的是S51单片机，已通过调试。-LCD1602 display program, using a S51 MCU has passed debugging.

keil编译,单片机资料,Can通讯。-keil compiler, microcontroller information, Can communications.

ARM的计数器中断实验。是基于Keil For Arm的。-ARM interrupt counter experiments. Is based on the Keil For Arm.

atmega16 用pwm 产生正弦波 示波器观察ok-ATmega16 generate sine wave using pwm oscilloscope observation ok

单片机DA转换源码，在串口调试助手下可以查看发送到串口的转换结果，波特率设置为2400 -Singlechip DA conversion source, in the serial debugging assistant can view the sent to serial conversion results, the baud rate is set to 2400

6段数码管分别显示，时，分，秒，四个按键，K1（P0.0），K2（P0.1）， K3（P0.2），K4（P0.3），四个按键用来调时间的，按下K1，所有位都清零显示，然后按下K2，秒在闪烁，继续按K2分闪烁，不段地按K2 秒--分--时切换着闪烁，在某位闪时按下K3相应位加一，确认调整，按K4，取消调整再按K1。在K1按下以后才有调时的功能，如果K1没有按下，按别的键没有反映。这为了在加点按键功能留着用 -6 respectively of the digital control, when, minutes and seconds, four keys, K1 (P0.0). K2 (P0.1), K3 (P0.2), K4 (width), the four keys to the transfer time, press the K1, All spaces are reset, then press K2, the scintillation seconds, according to K2 pm flickered. not according to K2 of seconds-- minutes-- when switching to flicker in certain press the flash-K3 corresponding increase in a confirmed adjustment by K4, then canceled K1 adjustment. K1 in the press will only be made after the transfer of function, if K1 pressed by other key is not reflected. This points to the function keys used Retention