-
用于单片机32bit内的快速开方(C51)
用于单片机32bit内的快速开方(C51)-32bit MCU for the rapid evolution (C51)
- 2022-06-21 07:57:56下载
- 积分:1
-
c8051f020的应用程序,主要为对ADC0的应用,使用其内置的温度传感器读取其片内温度值,并可以设置模拟输入口检测电压值...
c8051f020的应用程序,主要为对ADC0的应用,使用其内置的温度传感器读取其片内温度值,并可以设置模拟输入口检测电压值-C8051F020 applications, mainly for ADC0 applications, using its built-in temperature sensor to read the chip temperature, and can set the analog input voltage value detection
- 2022-05-14 20:15:53下载
- 积分:1
-
此书为keilC的调试心得,有助于开发过程中错误的理解,积累开发经验!...
此书为keilC的调试心得,有助于开发过程中错误的理解,积累开发经验!-Debugging keilC book for ideas and help to develop understanding of the process error, the accumulation of development experience!
- 2023-05-25 22:10:03下载
- 积分:1
-
bottom of the mouse Communication Theory and in
通过对鼠标底层通信原理及协议的深入分析,探讨了鼠标在单片机系统中的应用价值与可行性,并介绍了鼠标接口软件设计的原理及方法,给出了单片机与Microsoft鼠标的具体接口程序。-bottom of the mouse Communication Theory and in-depth analysis of the agreement to explore a mouse in the SCM system of value and viability, and introduced a mouse interface software design principle and the method of the SCM and Microsoft mouse interface to the specific procedures.
- 2023-04-29 10:45:03下载
- 积分:1
-
62256c language reading and writing process, after authentication, direct access...
62256c语言读写程序,经过验证,可以直接使用-62256c language reading and writing process, after authentication, direct access to
- 2022-12-18 19:30:03下载
- 积分:1
-
51单片机最新技术
51单片机最新技术-51 SCM latest technology
- 2023-01-03 11:35:04下载
- 积分:1
-
C51单片机实现红外数据的通信与传输 数据通过串口格式化 38 KHZ载波...
C51单片机实现红外数据的通信与传输 数据通过串口格式化 38 KHZ载波-C51 MCU infrared data communications and the transmission of data through the serial format 38 kHz carrier
- 2023-06-23 14:45:03下载
- 积分:1
-
各位朋友,本人买的12864液晶屏已经调试通过,下面是源程序,无偿奉献,有需要的赶快下啊,这可花了我一个星期啊(jjcool)...
各位朋友,本人买的12864液晶屏已经调试通过,下面是源程序,无偿奉献,有需要的赶快下啊,这可花了我一个星期啊(jjcool)-friends, I bought the 12864 debug screen has passed, Below are the source, with the dedication that are needed quickly under ah, it could take me a week ah (jjcool)
- 2022-05-12 17:46:32下载
- 积分:1
-
状态1:正常时,8个LED发光二极管(彩灯)循环点亮。
• 状态2:有报警时,蜂鸣器发出报警声(用P3.3接一个按键,模拟产生报警信号。当开关合上...
状态1:正常时,8个LED发光二极管(彩灯)循环点亮。
• 状态2:有报警时,蜂鸣器发出报警声(用P3.3接一个按键,模拟产生报警信号。当开关合上,发生报警;当开关断开,报警停止。用P3.7输出音频信号驱动扬声器,作为报警信号),同时8个LED发光二极管(彩灯)闪烁。
P3.2接一个按键,用于消除报警-Status 1: normal, eight LED light-emitting diodes (lantern) light cycle.
- 2022-04-28 18:39:28下载
- 积分:1
-
利用LABview做的解无线传感器节点的包的数据的程序
利用LABview做的解无线传感器节点的包的数据的程序-Does the solution make use of Labview wireless sensor nodes process data packets
- 2022-10-07 06:30:03下载
- 积分:1