AMIS to develop single

基于矢量控制的永磁同步交流伺服电机控制系统 可以用的源程序-Based on vector control of permanent magnet synchronous AC servo motor control system can use the source code

利用北京青云的128×64的台湾硒创的ST7920的液晶显示程序，利用高效的总线并行访问，非串行，访问CGRAM,具有图形显示功能，可用在实时波形计算显示-Beijing Qingyun use the 128 × 64 selenium created in Taiwan

TI公司的2407的一些代码和应用实例，主要应用电机控制，包括常用的电机控制算法-some of the 2407 code and application examples, application of motor control, used in the motor control algorithm

合众达开发的2812板的测试历程，串口测试程序-America to the development of the 2812 board test process, serial testing procedures

5509A DSP iic_spi 程序源代码-5509A DSP iic_spi source code

dsp 5509a IO程序测试程序 ,12M晶振, 可以使用示波器观看-dsp 5509a IO testing procedures, 12M crystal, you can use the oscilloscope Views

ti――dsp2812，AD转换低层驱动程序，直接应用-ti- dsp2812, AD conversion low-level driver, the direct application of

PROTEL99SE布线的基本流程.zip-PROTEL99SE the basic wiring process. Zip

Blackfin C FFT code example-Blackfin C code example FFT

基于DSP网络中的TCP/IP协议研究，本文通过对TCP/IP协议的具体分析,解决了以数字信号处理器(DSP)为核心的局域网络DSP端的IP地址问题,实现了DSP与PC机之间的UDP协议通信-DSP-based network TCP/IP protocol, the paper through the TCP/IP protocol specific analysis to solve a digital signal processor (DSP) as the core DSP LAN side IP address problem, the realization of the DSP and PC machine UDP protocol communication between