普通波形发生器 开发环境：VisualBadsic

能够学会用单片机控制打印，还能深入了解单片机内部机理。-to learn how to use the SCM control print, but also in-depth understanding of the internal mechanism of SCM.

C51源程序和文档-C51 source code and documentation

CC1000为RF芯片，作为无线通信处理芯片，本程序是基于PIC72作为处理器。频段为433.92M，具有多种通信方式，通信速度可达到65K。-CC1000 RF chip, as wireless communications processing chip, the procedure is based on the PIC72 as the processor. For 433.92M band with a variety of means of communication, communication speeds up to 65K.

485单相电能表开发程序，液晶显示。采用AD7755设计，可与掌上电脑连机通信设置各种电能表参数。-485 single-phase energy meter development process, liquid crystal display. Design using AD7755 can be connected Pocket PC communication settings of various parameters of energy meter.

单片机模数转化程序，主程序时一位从事单片机工作多年的资深教授所编写-SCM modulus conversion process, the main program in a microcontroller when a senior professor for many years to prepare

8051 Absolute Encoder Positioner How to connect and drive absolute position encoder with SSI serial interface. The encoder has been made by Siemens (6FX2001-5FS12). Archive contains: 1) schematic, 2) source in C and Assembler

51+PDIUSBD12源代码-51 PDIUSBD12 source code

显示界面的显示程序显示 界面的显示程序-Show interface show interface display program to display the show interface display program

/* 程序详细功能介绍： *当按下按键P3.3 ，AT89S51单片机产生“叮咚”声从P3.2端口输出 *程序设计方法 * 1． 我们用单片机实定时/计数器T0来产生700HZ和500HZ的频率，根据定时/计数器T0，我们取定时250us， * 因此，700HZ的频率要经过3次250us的定时，而500HZ的频率要经过4次250us的定时。 * 2． 在设计过程，只有当按下SP1之后，才启动T0开始工作，当T0工作完毕，回到最初状态。 * 3． “叮”和“咚”声音各占用0.5秒，因此定时/计数器T0要完成0.5秒的定时，对于以250us为基准定时2000次才可以。 */-/* Procedure detailed functional Introduction:* When pressing the button P3.3, AT89S51 Singlechip a

大值的驱动电压，否则会造成液晶模块的损坏。如果在低于或大致等于典型驱动电压时，观察到了显示屏上有色调的变化，即显示域的底色略深于边缘的颜色，表明液晶模块电源连接正确，可以进人下一步工作。如-Large value of driving voltage, otherwise LCD module can cause damage. If less than or roughly equivalent to a typical drive voltage, the observed screen has color changes, which indicates that the domain a little deep background color at the edges, indicating that the LCD module power supply connections are correct, you can enter the next step. Such as