ucos ii V2.86，最新2.86版源程序及详细文档

一个ucos-ii2.51移植到gcc下的port.大概是一个韩国人做的。从UCOS网站上那个VC的port改进而来。使用和介绍请见RAR文件中的注释。-an CENTER-gcc ii2.51 transplanted to the port. About a Korean done. UCOS site from which VC improvement from the port. The use and presentation of RAR see the Notes document.

this the usbtester program to browse the communicatino between host and device-this is the usbtester program to browse the communicatino between host and device

该文件为uCOS-II实时嵌入式操作系统的详细使用教程，代码分析及源代码。教程中对uCOSII中代码各部分功能和模块分章列出，希望对使用和移植的朋友能够有所帮助。-This document gives uCOS-II real-time embedded operating system, the detailed use of tutorials, code analysis and source code. Tutorial on the uCOSII in various parts of the code features and module sub-chapters are listed in the hope that the use and transplantation of a friend can help.

优化过的ucGUI汉字库-optimized the ucGUI Store

uc/cosII for m68k 内核-uc/cosII for m68k kernel

关于ucos 在avr128 中应用用icc编译-CENTER on the application used avr128 icc compiler

1.板上的8 个按键分别分别代表数字1-8，按下一个按键将结果通过串口发送到PC机上显示； 2.使用两个定时器模块，分别定时为1ms 和100ms 产生中断，使用它们分别 产生1s的定时时间，将时间分别显示到数码管上； 3.外接PS/2小键盘，将按键的值通过串口显示到PC机上。(A panel of eight key representing the number 1-8 press a key the results sent through the serial port on a PC display (2) use two timer modules, respectively, of 1ms and 100ms timer generates an interrupt, use them, respectively, Produce the timing of the 1s, the time display to the digital control External PS/2 keyboard, the key value of displayed through the serial port to a PC.)

基于mega128的ucos参考源码，编译已通过，仅供学习-Based on the uCOS mega128 reference source, the compiler has passed, only to learn

2410开发板上电机转动控制的源代码，使用ARM2410自带的六路PWM-2410 development board motor rotation control of the source code, the use of the ARM2410, bringing their six PWM

uc gui v3.14源码 vc6.0编译通过-uc gui v3.14 compile source vc6.0