SCM control network chip communication (including rtl8019as driver, uip stack, c...

用C语言编写的PIC单片机一些例程源代码，很有参考价值。-C language prepared by the PIC source code of some routines, great reference value.

GPS开发，单片机接受代码，对于使用者非常重要-GPS

arm2410各种基础实验,已通过测试,内容: LCD控制器.doc 看门狗定时器.doc 定时器.doc 中断控制器.doc DMA 控制器.doc ad.doc 7279键盘和数码管.doc IIC 总线接口.doc IIC 总线接口.doc RTC.doc UART.doc-arm2410 various experimental basis, has been tested to be content: LCD controller. doc watchdog timer. doc timer. doc interrupt controller. docDMA controller. docad.doc7279 keyboard and digital tube. docIIC bus interface. docIIC bus interface. docRTC.docUART.doc

时钟芯片DS1302的设置、读取和测试程序-DS1302 clock chip settings, read and test procedures

基于AT89C51和DS18B20的最简温度测量系统 温度检测的传统方法是使用诸如热电偶、热电阻、半导体PN结之 类的模拟温度传感器。信号经取样、放大后通过模数转换，再交自单片机处理。被测温度信号从温敏元件到单片机，-Based on AT89C51 and Jane DS18B20 most temperature measurement system temperature detection is the use of traditional methods such as thermocouples, thermal resistors, semiconductor PN junction, such as analog temperature sensor. Signal sampling, amplified through the analog-digital conversion, and then deal with pay since the single-chip microcomputer. The measured temperature signal from the thermo-sensitive components to the microcontroller,

本文档包括单片机系统中常用到的时钟中断、通讯及键盘扫描等模块(见所附源程序)的说明。这些模块使用前后台系统模型。为达到最大的灵活性, 需要在用户工程中定义config.h文件, 在其中定义各模块可选参数的设置，而不是直接更改源代码。-this document, including SCM system clock used to the interruption communications and keyboard scanning modules (see accompanying source code) Note. These modules use before and after the Taiwan model. To achieve maximum flexibility in user defined config.h engineering documents, in the definition module optional parameter settings, and not to directly change the source code.

用ATmega8单片机驱动1602液晶显示，-ATmega8 using 1602 single-chip LCD driver,

用于51单片机的定时器延时子程序，对定时有要求的进!-For 51 single-chip timer delay subroutine, from time to time has requested to enter!

AVR单片机之间多机通信（通信方式采用的中断进行）-AVR single-chip multi-machine communication between (the interruption of communication used to carry out)

KeilC51开发,51单片机与E2PROM的接口程序,并且有串口与液晶的输出.-KeilC51 development, SCM and 51 E2PROM interface procedures, and a serial port with LCD output.