ti

用UCOS系统实现的MIPS平台源码，很不错的资料，源码可以直接用的-UCOS systems using the MIPS platform source, very good information source can be used directly

atmelsam7s64的usb数据传输例程-atmelsam7s64 the USB data transfer routines

his project was built and tested with WinAVR-20060125. Make sure the MCU target define in the Makefiles corresponds to the AVR you are using!! To build the code, just install WinAVR and run "make" from the console in echomaster and echoslave subdirs. "make program" will program the device if you have a AVRISP attached. Remember to set the AVR device to at least 8MHz. The AVR may use the programmable clock from MC1319x, just remember to check if the MC1319x and SPI communication is working FIRST! Otherwise you wont get any clock signal to the AVR and then you can t program it or reset the fuses! The MC1319x has default clock output of 32kHz so you will have to set your programmer to a very low frequency (

应用背景#包括

arm相关的学习资料,关于bios的源代码分析-arm relevant learning materials, bios on the source code analysis, etc.

Xilinx FPGA 的IP核，实现FFT功能的-Xilinx FPGA IP core, FFT function

sdconfig.h: 该文件为SD卡读写模块配置头文件，用户可根据实际硬件条件进行修改. SD目录 : SD卡读写模块的全部文件,一般不用修改. 建议sdconfig.h文件不要放于SD目录中，因为SD目录中的文件一般无须修改,而sdconfig.h通常会有改动. -sdconfig.h: The document for the SD card reader module configuration header files, the user hardware according to actual conditions can be modified. SD directory: SD card reader module all the documents, the general need not be amended. sdconfig.h document recommends not to put in SD directory, because the SD files in the directory are not normally required to be amended and the changes are usually sdconfig.h.

释放的晶晨半导体的Linux SDK（Buildroot里面版本2014年3月13日）与改写makefile文件的部分晶晨半导体LibPlayer来源，以符合我们的（croniccorey，j1nx，我......），晶晨半导体XBMC buildroot的。

深圳远峰PXA255开发板BSP，商用的，相关项目的板子可以参考。-The bsp of the intel pxa255 .

2104IRQ中断C语言编程-2104IRQ interruption C Programming Language