stm32 pmsm电机库做的例子，用于控制PMSM，BLDC电机源码

L298N是ST公司生产的一种高电压、大电流电机驱动芯片。该芯片采用15脚封装。主要特点是：工作电压高，最高工作电压可达46V；输出电流大，瞬间峰值电流可达3A，持续工作电流为2A；额定功率25W。内含两个H桥的高电压大电流全桥式驱动器，可以用来驱动直流电动机和步进电动机、继电器线圈等感性负载；采用标准逻辑电平信号控制；具有两个使能控制端，在不受输入信号影响的情况下允许或禁止器件工作有一个逻辑电源输入端，使内部逻辑电路部分在低电压下工作；可以外接检测电阻，将变化量反馈给控制电路。使用L298N芯片驱动电机，该芯片可以驱动一台两相步进电机或四相步进电机，也可以驱动两台直流电机。-L298N is produced by ST a high-voltage, high current motor driver chip. The chip uses 15-pin package. Main features are: high voltage, the maximum working voltage up to 46V output current, instantaneous peak current up to 3A, continuous operating current of 2A rated power of 25W. Contains two H-bridge high-voltage high-current full-bridge driver can be used to drive DC motors and stepper motors, relay coils and other inductive load using standard logic level signal control has two enable control terminal, input signal without affecting the case to permit or prohibit the device work a logic supply input, so that part of the internal logic circuits at low voltage work can be an external sense res

GUI文件，供参考~不需要我们就不会下载了，它

单片机串口发数，通过串口调试助手可以显示，COM口为实际使用的，波特率设置为：57600

适合KS8695X，可以tftp下载映象文件-Suitable for KS8695X, can download the image file tftp

嵌入式产品中的osip的源代码.-embedded in the source code osip.

博创ARM3000原理图，以及最小系统，包括AD,DA,LCD,键盘，以及常用外围设备-ARM3000 Fiberxon schematics, as well as the smallest system, including AD, DA, LCD, keyboard, and peripheral equipment used

硬件的cpu是arm920i2c总线和camera之间的连接驱动在嵌入式linux操作系统下编写-hardware cpu is arm920i2c bus and camera link between the driver in embedded Linux operating system prepared

顺舟SZ05的ZIGBEE模块，用LPC23XX对其进行配置-Shun Zhou ZIGBEE the SZ05 module, configured with its LPC23XX

armlpc2114，串口定时器及外部中断合并的源码。开发环境为ads1.2-armlpc2114, serial timer and external interrupt source combined. Development environment for ads1.2