单

the program is for contral system , using the PID.

ST7565 串行液晶驱动 + 多层液晶菜单 + Proteus仿真 ST7565 串行液晶驱动，用 晓奇工作室 Lcmzimo.exe提取字库，实现多层菜单，配有Proteus仿真。老是提示上传错误等会再传程序吧 -ST7565 Serial LCD driver++ Proteus simulation of multi-layer LCD menu serial ST7565 LCD driver, extract the font to use Xiaoqi studio Lcmzimo.exe to achieve multi-layer menu with a Proteus simulation. Always will be prompted to upload the error re-transmission of programs such as bar

本文介绍了AT89C2051单片机的性能和特点，并在分析了超声波测距原理的基本系统框图。该设计系统经校正后，其测量精度可达0.1米-This paper introduces the AT89C2051 performance and features, and the analysis of the ultrasonic distance measurement principle diagram of the basic system. The design of the system calibration, measurement accuracy of 0.1 meters

数控直流稳压电源，单片机实现直流数控稳压电源,可调电压为0-12伏,步进为0.1伏

24位的AD，ADS1211的SPI通讯，ARM7代码-24

用PIC16F877控制电动自行车的源程序，配有大量的说明！-PIC16F877 controlled by the source electric bicycle,配有大量note!

本资料是本人在网上收集到的两款时钟芯片ds1302和sd2400的读写程序，适用于单片机开发时钟-This information is collected from the I-line two clock chip ds1302 and sd2400 literacy program for developing MCU clock

c8051f340 USB传输 固件驱动， c8051f340 USB传输 固件驱动，-transmission c8051f340 USB drive firmware, c8051f340 USB transmission firmware-driven,

本装置是一个以HT46R71D 为主芯片，配合传感器组成的汽车轮胎气压检测装 置，最终取高三位有效值于LCD 显示，有四种显示单位供切换（Psi、Bar、Kpa、 Kgf/cm2）。本装置仅为参考范例，使用时，为提高准确度，建议多量测些组数 据来构建Sensor Output Voltage - Discharge Time (V-T)表格，并作相应校准。-This device is a HT46R71D-based chips, with sensors detecting vehicle tire pressure devices, and ultimately take the high-three RMS in LCD display, there are four types of display units for switching (Psi, Bar, Kpa, Kgf/cm2). Only reference to an example of the device, when used to improve the accuracy of the proposed多量measured set of data to build more Sensor Output Voltage- Discharge Time (VT) forms, and the corresponding calibration.

针对MSP430单片机开发的电机控制程序。是一个较详尽和完善的程序。-MSP430 development for single-chip motor control procedures. Is a more detailed and comprehensive procedures.