motorola jw32 usb 源码

此为基于ARM的LCD液晶显示器的程序,采用C语言编写,产生正弦曲线-This is based on the ARM-LCD liquid crystal display procedures, the use of C language, resulting in sinusoid

DNW0.50A软件的源代码，在ARM2410上面通过串口和USB口烧写操作系统镜像时必须用到的软件。-DNW0.50A software source code, in the ARM2410 above the mouth through the serial port and USB programmer to be used for mirroring the operating system software.

arm下编写的超时处理程序，测试功能完好-prepared under the arm of overtime treatment procedures, test function intact

Boot code for ARM-720T, ARM-920T, XScale, SA1100 and EPXA-Boot code for the ARM-720T ARM-920T, XScale, SA1100 and EPXA

STC89C52 EEPROM的驱动代码，带功能测试-STC89C52 EEPROM driver code, with functional tests

按键驱动程序示例, 按键驱动程序的描述，基于up netarm2410 s 开发平台-Key driver sample

基于ARM7的开发板的彩色液晶屏绘图试验程序，文件里有程序的详细注释，对与在此基础之上的二次开发非常方便-based on the ARM7 development board LCD graphics testing procedures, the documents in detail the procedures Notes right and the basis of this second development is very convenient

S3C2410完全开发流程,实验源码,．S3C2410 基础实验 -S3C2410 fully developed flow, the experimental source. S3C2410 based on experimental

该项目包含驱动DBOX-1采用LED-DOX阿尔法显示由STM32F4Disco板代码。我需要一个CI-V总线监视器用MODEN ICOM业余无线电收发器IC-756Pro3 NAND IC7400到CONTROLL一个旧的Mosfet RF功率放大器。串行端口用于建立由收发器sended一个CI-V接口和显示器显示的接收CIV命令，如果VFO移动。该项目采用的Keil IDE，并允许在32个字节的免费限于编译。该DBOX1是诺基亚，它使用8位字母数字点阵导致的与内置的解码器一个过时的机顶盒。该显示器是由两线串行线连接到主机（CLK，DATA）并支持自定义字符像帕克曼：-）我不得不建立一个接口的CI-V总线的部份是由光电耦合器电分离得到收发器保存。最接口，我知道，一点儿也不做 - 一种耻辱。

基于ARM7的开发板的外部存储器接口程序，文件里有程序的详细注释，对与在此基础之上的二次开发非常方便-based on the ARM7 development board external memory interface, document the procedures detailed notes, right and the basis of this second development is very convenient