using TI's TMS320C5402 DSP generation and DTMF recognition algorithm. No pas...

tigersharc ts101 循环程序-tigersharc ts101 cycle procedures

DSP CPU定时器的使用 中断的使用 如何进入中断-The use of DSP CPU timer interrupt interrupted the use of how to enter

资源描述这两个头文件是对2833x系列，DSP2833X _device.h 和DSP2833x_Cpu tiimer.h

Dsp原理及应用第七章节程序源码，可以为您引入Ｄｓｐ的开发领域，-Dsp principle and application procedures for the seventh chapter source code, you can introduce Dsp the development field,

在DSP开发板上调试通过的XF引脚测试程序，可以使发光二极管交替闪烁-in DSP development board debugging XF pin through the test procedure can alternately blinking LED

BLACKFIN BF533 的启动初试化程序-BLACKFIN BF533 initial start-up procedure

svpwm空间电压矢量控制的核心算法，用于电机控制-svpwm space vector control algorithm for motor control

硬件要求：基于合纵达的SEED-VPM642的示例。软件要求：CCS2.2以上版本。对于想用DSP/BIOS开发的同道中人来说是很好的学习实例。-Hardware Requirements: Based on the combined vertical up the SEED-VPM642 example. Software Requirements: CCS2.2 above. For want to use DSP/BIOS development for the fellow human is a very good learning examples.

MAX6951是紧凑的共阴极显示驱动器，可通过SPI、QSPI、MICROWIRE兼容的串行接口将微处理器连接到独立的7段LED数码管、条形图或分立LED。本程序利用TI公司DSP LF2407A 实现MAX6951驱动6位7段数码管。硬件连接采用IOPC0做片选信号，片上SPI外设与MAX6951通信。绝对原创，首次共享！-MAX6951 is a compact, common-cathode display driver is available through SPI, QSPI, MICROWIRE-compatible serial interface microprocessor connected to a separate 7-segment LED digital tube, bar graph, or discrete LED. This procedure using TI" s DSP LF2407A achieve MAX6951 driving six 7-segment digital tube. IOPC0 to do with the hardware to connect the chip-select signal, on-chip SPI peripherals communicate with the MAX6951. Absolutely original, for the first time to share!

dsp28335与fpga采用emif外部接口通信的程序，fpga是飓风系列