模糊聚类的matlab程序

this matlab file to simulate mimo capacity

利用自适应滤波法研究从宽带信号中提取单频信号的方法(Adaptive filtering of broadband signals from a single frequency signal extracting method)

渐开线齿轮的齿廓三维建模，渐开线齿轮的齿廓三维建模(Involute tooth profile of the line gear three-dimensional modeling, three-dimensional modeling of involute tooth profile of the line gear)

Load Frequency Control

用matlab产生一个频率为1Hz的余弦信源 ，设载波频率20Hz， ,试画出： ? AM及DSB调制信号的时域波形； ? 采用相干解调后的AM及DSB信号波形； ? AM及DSB已调信号的功率谱； ? 调整载波频率及m0，观察分的AM的过调与DSB反相点现象。(A cosine source with a frequency of 1Hz is generated by MATLAB, and the carrier frequency 20Hz is set. The time domain waveform of AM and DSB modulation signals; Adopt coherent demodulation of AM and DSB signal waveforms, The power spectrum of AM and DSB modulated signals, Adjust the carrier frequency and M0, observe the AM overshoot and DSB inverting point phenomenon.)

非常好的matlab GUI开发经验。 一. 基本知识： 二. Matlab的I/O文件操作使用技巧和总结: .......(Very good matlab GUI development experience. One. Basic knowledge of: the Second. Matlab' s I/O file operations using the techniques and concluded: .......)

基于广义MUSIC的相干分布式信号源的DOA估计(Distributed coherent signals DOA estimation based on the MUSIC algorithm)

通过西奥道森气动力模型求解气动力，并通过v-g法求解颤振速度与颤振频率(Solve the aerodynamic force through the Theodorsen aerodynamic model and solve the flutter velocity and flutter frequency through the v-g method)

用matlab画图分析lamb波的原始激励信号和接收信号，并对比分析的差别(Using matlab drawing analyzes the original lamb wave excitation signal and the received signal, and compare the difference analysis)

说明：  信号x（n）=sin(2*pi*0.05*n)+2*cos(2*pi*0.12*n)+w（n），求N=365的相关函数和功率谱(Signal x (n) = sin (2 * pi * 0.05 * n) + 2 * cos (2 * pi * 0.12 * n) + W (n), the correlation function and power spectrum of n = 365 are obtained)