AVR单片机开发的源代码，对于单片机开发人员有很大的帮助作用。...

有关于DS18B20的温度读取，控制电炉的温度，并且带有上下限警报-Read on DS18B20 the temperature and control the temperature of furnace, and with the upper and lower limits alarm

介绍80C51单片机的Keil C51编程:80C51的系统结构,汇编语言,C51语言,开发实例及一些注意事项.推荐!-Introduction 80C51 MCU Keil C51 Programming: 80C51 system architecture, assembly language, C51 language, the development of examples and some attention. Recommended!

这是一个CAN总线通信的节点程序，是我自己编写的，希望指正。-This is a CAN bus communication nodes procedures, the preparation of my own, and I hope correct me.

man/machine/interface设计开发环境为ICC,可以编译成汇编,直接下栽到嵌入式avr单片机进行控制-man/machine/interface design and development environment for the ICC, compile a compendium, crashed directly to the embedded microprocessor control avr

PIC18 ECAN DEMO -PIC18 ECAN DEMO

单片机计时仪器，不错的参考程序。接口可以自行修改即可-Single-chip timing equipment, a good reference for the procedure. Interface can be modified to

用C-BASEIC语言编写的805X单片机计算子程序P=A0+A1*X+A2*X*X+A3-with C-language BASEIC the 805X MCU calculation subroutine P = A0 A1 A2* X* A3* X* X* X* X* X

有关液晶点阵的单片机程序，希望对初学者有一定的用处，大家看了就知道了。-the SCM process, and I hope to have some beginners use, we read will know.

这是个串口液的驱动。希望给有用的朋友以帮助。128*64点阵-This is a fluid-driven serial port. Want to give a useful friend to help. 128* 64 lattice

6段数码管分别显示，时，分，秒，四个按键，K1（P0.0），K2（P0.1）， K3（P0.2），K4（P0.3），四个按键用来调时间的，按下K1，所有位都清零显示，然后按下K2，秒在闪烁，继续按K2分闪烁，不段地按K2 秒--分--时切换着闪烁，在某位闪时按下K3相应位加一，确认调整，按K4，取消调整再按K1。在K1按下以后才有调时的功能，如果K1没有按下，按别的键没有反映。这为了在加点按键功能留着用 -6 respectively of the digital control, when, minutes and seconds, four keys, K1 (P0.0). K2 (P0.1), K3 (P0.2), K4 (width), the four keys to the transfer time, press the K1, All spaces are reset, then press K2, the scintillation seconds, according to K2 pm flickered. not according to K2 of seconds-- minutes-- when switching to flicker in certain press the flash-K3 corresponding increase in a confirmed adjustment by K4, then canceled K1 adjustment. K1 in the press will only be made after the transfer of function, if K1 pressed by other key is not reflected. This points to the function keys used Retention