ARM7的UART驱动程序 可以自由配置缓存大小 驱动函数集 以及接口简单 很适合初学者提高自己的驱动开发能力的参考程序 产品级别的代码 注释很详尽 但需要自己...

基于ARM芯片的代码烧录程序文件-based on the ARM chip code copying files

nand flash 的测试代码，非常好，值得研究 -nand flash test code, very good, worthy of study

ARM LPC2129 AD中断范例 -LPC2129 ARM interrupted example AD

This package contains example software and associated documentation for the ColdFire MCF5249 microprocessor. The software includes sample processor initialization routines for the MCF5249 running a M5249C3 evaluation board as well as the following sample applications: simple - empty application template fat - factory acceptance test for the M5249C3 The software has currently been built and tested under Metrowerks CodeWarrior -This software package contains an example d associated documentation for the ColdFire MC F5249 microprocessor. The software includes s ample processor initialization routines for t he MCF5249 running a M5249C3 evaluation board a s well as the following sample applications : simple-empty application template fat-facto ry acceptance test for the M5249C3 The software currently has been built and tested under Metro werks CodeWarrior

AT91M42800A的bootloader源代码，实现了中断处理以及中断矢量。-RISC Bootloader source code, achieve interruption of treatment and interrupt vectors.

arm例程 可作为arm简单的例子 -arm

命令行的sjf2410工具，可用于2410平台下的flash烧写。 注意：这个版本与其他版本的不同之处在于：它可以设置并口地址，方便在使用PCI转并口时使用； 它可以自动安装giveio驱动，简化操作，更傻瓜，更方便-Sjf2410 command-line tool can be used under the 2410 platform flash programmer. Note: this version with other versions of the difference is: it can set the parallel port address, to facilitate the use of PCI to the use of parallel port it can automatically install giveio drive to streamline the operation, but a fool, more convenient

sdconfig.h: 该文件为SD卡读写模块配置头文件，用户可根据实际硬件条件进行修改. SD目录 : SD卡读写模块的全部文件,一般不用修改. 建议sdconfig.h文件不要放于SD目录中，因为SD目录中的文件一般无须修改,而sdconfig.h通常会有改动. -sdconfig.h: The document for the SD card reader module configuration header files, the user hardware according to actual conditions can be modified. SD directory: SD card reader module all the documents, the general need not be amended. sdconfig.h document recommends not to put in SD directory, because the SD files in the directory are not normally required to be amended and the changes are usually sdconfig.h.

与合作 UART STM32F103 通过 CMSIS 图书馆。初始化、 原始写入和读取从端口。

基于ARM的启动代码-ARM-based boot code