Digital voice playback system, through the AD sampling, single

65526ram应用实例 看过即会不看后悔-65526ram application examples will be seen that the

905无线模块关于主机通信的程序。

采用ST的UPSD33XX系列单片机的双串口，实现串口通信的波特率转换，一边为25针串口，一边为9针串口，两天波特率可在程序中修改！文件中包括原理图，PCB和源程序-UPSD33XX using ST"s Microcontroller series dual serial ports, Serial communication baud rate conversion, the side of the 25-pin serial port side of the 9-pin serial ports, two days baud rate can change in the proceedings! Documents including schematics, and source of PCB

指纹识别，模块代码,算法，KEIL工程，可编译-Fingerprint Identification Module Code

包含了msp430单片机上的ADC、定时器A、定时器B、基础时钟、看门狗的初始化及中断程序。基本示例程序-Msp430 on a single chip that contains the ADC, timer A, Timer B, basic clock, watchdog and interrupt the initialization process.

这是一个用于单工无线呼叫系统中完成语音和数据发送的程序，包括对键盘的扫描以及对液晶屏幕的显控-This is for a single system for wireless calls completed voice and data transmission procedures, including the right of the keyboard scan and the right of the LCD screen and Control

帮朋友写的一个用MCS-51的IO口模拟PWM使外接LED亮度渐变的程序，虽然程序小，不过注释清楚，并已调试OK。-written for a friend with a MCS-51 simulation of the IO mouth so that external PWM LED brightness gradual process Although procedures for small, but clearly Notes, and debugging OK.

单片机控制的条码打印机程序,程序简单,功能齐全.-MCU-controlled bar code printer program, the program simple and functional.

TS12864A-3汉字库。有需要的朋友请下载-TS12864A-3汉字库. Friend in need, please download

P1.7～P1.0接发光二极管L8～L1，要求利用单片机内部定时器1，按方式1工作，每0.01秒T1溢出中断一次。要求编写程序模拟时序控制装置。开机第1秒钟L1、L3亮，第2秒钟L2、L4亮，第3秒钟L5、L7亮，第4秒钟L6、L8亮，第5秒钟L1、L3、L5、L7亮，第6秒钟L2、L4、L6、L8亮，第7秒钟8个发光二极管全亮，……一直循环下去。fosc=11.0592MHz-P1.7- P1.0 then LED L1 to L8, by using a timer internal microcontroller, a work by the way, every 0.01 seconds T1 interrupted an overflow. Simulation prepared timing control device. Boot 1 seconds L1, L3- liang, two seconds L2- L4, L5 three seconds, L7- liang, 4 seconds L6, L8-liang, 5 seconds L1, L2, L5, L7- liang, 6 seconds L2, L4, L6, L8- , 7 seconds 8-LED whole ... has been the cycle continues. 11.0592MHz fosc =