描述msp430的端口控制以及频率设定 的一个简单程序

寻轨迹小车smartScar全面的全国电子设计大赛-Track car search a comprehensive national electronic smartScar Design Competition

tlc5615的驱动程序。程序也用过，比较好， 非常高兴能和大家分享。-tlc5615 drivers. Procedures used were relatively good, and very pleased to share with you all.

CRT驱动IC英文资料,是单片机开发者在开发CRT时的一个重要参考!-CRT driver IC information in English is a single-chip developers in the development of CRT at the time of an important reference!

AVR单片机的EEPROM的读写程序, 通过TWI接口读写.-AVR MCU EEPROM reading and writing process, reading and writing through the TWI interface.

RTC芯片，ds1302的芯片驱动程序，-RTC chip, ds1302 chip driver

周立功MAGICARM2410开发板配套wince实例源代码，234章-Ligong MAGICARM2410 weeks wince development board supporting examples of source code, Chapter 234

利用多模式调制解调器芯片CMX868能直接通过高速串行总线与单片机串行接口进行通信这一特点设计的一套采用单片机来控制CMX868芯片的数据传输系统，握手协议部分-The use of multi-mode modem chip CMX868 directly by high-speed serial bus and the microcontroller serial interface to communicate with this feature set designed to use microcontroller to control the CMX868 chip data transmission system, part of the handshake protocol

这是一个简单的红外解码程序，是针对9ms起始码和4.5ms结束码的红外信号。晶振用的是11.0592M的，经测试能用。-This is a simple infrared decoding procedure is 9ms start code and end code 4.5ms infrared signal. 11.0592M crystal is used, and can be tested.

msp430f149键盘中断程序，用端口中断。通过实验验证-msp430f149 keyboard interrupt procedures, using ports interruption. Experimental verification

一个简单的C51控制5位显示的程序,还有控制摩尔开关的程序大家可以-a project about C51