非接触式无线巡更系统实现讲解，希望能给大家带来帮助

LED的应用很广泛了。上传一个 用SST89E564RD芯片驱动LED的参考程序，与大家共享。-LED applications is wide. Upload SST89E564RD with a LED driver chip reference procedures, and share.

洗衣机汇编程序，有四种洗衣模式：标准、经济、单独和脱水。-Washing machine assembler, laundry four modes: standard, economy, and dehydration alone.

使用AT89C52单片机，12MHZ晶振，P0口读入AD值，P2口作AD控制，用共阳LED数码管， P1口输出段码，P3口扫描，最高位指示通道（0-7）。-AT89C52 single-chip microcomputer use, 12MHZ crystal, P0 I read into the AD value, P2 for the AD population control, with a total of Yang LED digital tube, P1 port output above code, P3 port scan, the maximum bit instructions channels (0-7).

IC卡操作软件:AT88SCl604芯片的操作模式有五种。它们是通过配PGM、RST、CLK等引脚信号及内部地址计数器(IAC)的状态组合来实现。 (1) 芯片复位操作： AT88SCl604有两种复位方式:上电复位和控制复位。 上电复位： 上电复位是当芯片加电时的最初状态。上电复位属于芯片 内部复位。它将使芯片内部所有的隐含标志复位到"0"状态。并使地址计数器复位到0位。 控制复位： 当CLK为低时，在RST脚上的一个下降沿将便芯片产生复位操作。 控制复位是将地址计数器复位到0位，而不影响任何内部标志的状态。-IC Card operating software : AT88SCl604 chip mode of operation there are five. They are allocated by PGM, RST, etc. pin CLK signal and the internal address counter (IAC) portfolio of the state is to be achieved. (1) chip reset operation : reduction AT88SCl604 two ways : power-on reset and reset control. Power-on reset : power-on reset when the chip is in power at the initial state. Power-on reset the internal chip is reset. It will enable all internal chip implied signs reset to "0" state. Make address counter reset to 0. Reset control : When the CLK for the low, the RST feet of a falling edge chips will have to reset operation. Reset control is to address counter reset to 0, without prejudice to any signs of internal sta

模拟遥控器编码，可是模拟三个按键的编码，用c语言编写。-Simulation of the remote control code, but simulate the three keys encoding, using c language.

应用于51芯片的很经典的串口通讯程序源代码 （采用fifo方式）-chips used in 51 of the classic serial communication program source code (using fifo mode)

C51单片机与PC机串行通信源程序，现与大家分享-C51 MCU and PC serial communication source, is to share with you

w77e58单片机的双串口 的操作，寄存器的设置和 串口读写等-w77e58 SCM dual serial operation, the setup and register read and write, etc. Serial

自己写的12864驱动程序，在MCS―51上调试过，我认为不错-Wrote it myself, 12864 drivers, increase in the MCS-51 tried, I think it is true

avr steper motor control