SPCE061电子

96/196单片机的C语言例程-stable SCM C Language Programming

控制电机运动的G代码程序,如果对G代码不清楚,请先看懂G代码,然后再看本程序-Control motor movement, G code program, if the G code is not clear, please understand G code, and then look at the procedures

HT24 系列的EEPROM 总共8 个管脚，三个为芯片地址脚A0、A1、A2，在单片机对它进行操作时，从SDA 输入A0、A1、A2 数据和芯片外部A0、A1、A2 所接地址需一一对应。一个为芯片写保护脚WP，WP 脚接低电平时，芯片可进行读写操作；WP 脚接高时，芯片只可进行读，不可进行写。 另外两个管脚为电源脚VCC，VSS。 用单片机对HT24 系列的EEPROM 进行控制时，HT24 系列的EEPROM 的外部管脚VCC、VSS、WP、A0、A1、A2 根据需要，对应接上，SDA、SCL 接到单片机控制脚上。-HT24 Series EEPROM total of 8 pins, three pins for the chip address A0, A1, A2, in the microcontroller to operate it, from SDA input A0, A1, A2, and chip external data A0, A1, A2 of the Then one correspondence address must be in. One for the chip, write-protect pin WP, WP feet then low, the chip can be read and write operations WP pin is high then, the chip can only be read, not write. The other two pins for the power pin VCC, VSS. With the microcontroller on the HT24 Series EEPROM control when, HT24 Series EEPROM external pin VCC, VSS, WP, A0, A1, A2 according to the needs of the corresponding connected, SDA, SCL receives SCM control feet .

USB带宽测试的程序，针对CY7C68013的USB2.0接口芯片，编译环境为KEIL -USB bandwidth test procedures against CY7C68013 USB 2.0 interface chip, compile environment for KEIL

提供了LED点阵显示的Proteus仿真电路，和汇编代码。-LED dot matrix display provides a simulation circuit of the Proteus, and assembly code.

ARM的计数器中断实验。是基于Keil For Arm的。-ARM interrupt counter experiments. Is based on the Keil For Arm.

GUI_Builder 一个使你快速设计你的Gui的软件-GUI_Builder one allows you to quickly design the software of your Gui ~ ~

学习51的要关注哦,是STC的烧录软件,方便51单片机学习,通过串口就可一烧写程序,减少开发费用,-learning the concern Oh, STC is the replication software for 51 MCU study, through a serial port can be burning, reduce development costs,

一个基于at89s51控制用的系统 电路图-AT89S51-based control system circuit diagram

模数转换adc0832及液晶显示LM016的应用示例-Analog-to-digital converter and liquid crystal display adc0832 application example of the LM016