基于at91连接4x4键盘的开发示例，包括硬件连接，驱动的开发，中断的处理等。...

日本北斗电子系统TCP/IP以太网机设计

s3c2410 ads下的测试程序移植到 iar ewarm v5.2；包括 Please select function : 0 : Please input 1-14 to select test 1 : Real time clock display 2 : 4 key array test 3 : Buzzer test 4 : ADC test 5 : IIC EEPROM test 6 : Touchpanel test 7 : 3.5# TFT LCD 240*320 test 8 : UDA1341 play audio test 9 : UDA1341 record audio test 10 : IRDA test 11 : SD Card write and read test 12 : COM port ( UART2 ) test-s3c2410 ads test procedure under the transplanted into iar ewarm v5.2 including Please select function: 0: Please input 1-14 to select test 1: Real time clock display 2: 4 key array test 3: Buzzer test 4: ADC test 5 : IIC EEPROM test 6: Touchpanel test 7: 3.5# TFT LCD 240* 320 test 8: UDA1341 play audio test 9: UDA1341 record audio test10: IRDA test11: SD Card write and read test12: COM port (UART2) test

用811实现的ARM7的USB主机详细程序-With 811 of the ARM7 realize the USB host detailed procedures

NXP产品LPC23XX的开发板的原文件,包含了源代码,使用手册,开发板线路图-NXP Products LPC23XX the development board of the original document, including the source code, user manual, development board circuit diagram

基于三星的44b0或2410微处理器的闪存控制程序-44b0-based Samsung

2410MMU总结，一份很好的关于2410MMU 的总结报告-2410MMU sum up, a good summary report on the 2410MMU

使用键盘上的上、下、左、右四个按键，可以分别控制led1,2,3,4,每个LED 对应的Port 请参考“实验平台介绍”说明文档。要求按下 上面提到的四个按键中间的一个按键后，该按键对应的led 被点亮，持续1 秒钟以后led 熄 灭。-Use the keyboard on the upper and lower, left, and right buttons, can control led1, 2,3,4, each LED corresponding to the Port, please refer to " experiment on" documentation. Requirements of the four above-mentioned press the middle button of a button, the button that corresponds to being light led, continuous 1 second later led out.

ARM应用系统开发详解，基于S3C4510B的系统设计。-ARM Elaborates on application systems development, based on S3C4510B the system design.

ARM-LPC23xx系列DAC源代码。-ARM-LPC23xx Series DAC source code.

模糊自整定PID控制的MATLAB源代码-PID