C8051

本装置是一个以HT46R71D 为主芯片，配合传感器组成的汽车轮胎气压检测装 置，最终取高三位有效值于LCD 显示，有四种显示单位供切换（Psi、Bar、Kpa、 Kgf/cm2）。本装置仅为参考范例，使用时，为提高准确度，建议多量测些组数 据来构建Sensor Output Voltage - Discharge Time (V-T)表格，并作相应校准。-This device is a HT46R71D-based chips, with sensors detecting vehicle tire pressure devices, and ultimately take the high-three RMS in LCD display, there are four types of display units for switching (Psi, Bar, Kpa, Kgf/cm2). Only reference to an example of the device, when used to improve the accuracy of the proposed多量measured set of data to build more Sensor Output Voltage- Discharge Time (VT) forms, and the corresponding calibration.

汇编语言，用定时器中断，实现输出占空1比1的方波波形-Assembly language, using the timer interrupt, the realization of output accounted for one than the one empty square waveform

stc单片机的iap程序，用c51写的，是从汇编转换过来的-SCM STC IAP procedures, using C51 write is from the compilation of the conversion from the

可用的MSP430JTAG调试器，含protel格式的电路图和PCB图-available MSP430JTAG debugger, Protel format with the circuit and PCB plans

Atmega8和MCP2515实现CAN通讯源码代码,测试通过，希望对大家有用-CAN communication Atmega8 and MCP2515 to achieve source code, test and hope for all of us

C51定时器应用－实时时钟-C51 timer application-real-time clock

sja1000与stc单片机的硬件程序，简单的通讯程序-SJA1000 MCU hardware and the STC process, a simple communication program

时钟芯片DS1302的设置、读取和测试程序-DS1302 clock chip settings, read and test procedures

利用8051单片机驱动蜂鸣器，实现音乐发声功能。-8051 drivers to use buzzers realize music vocal function.

1.2v镍氢电池智能充电器，内含C源代码，原理图以及PCB文档，采用△V方法检测电压变化。-1.2V Ni-MH battery smart charger, includes C source code, schematic and PCB documents, the use of △ V voltage change method.