本要求适用于Microcon

无线解码程序，是用于多种无线报警主机的解码-wireless decoding procedure is used in a variety of wireless alarm host decoder

EZ430-rf2500无线网络源代码，配套实验源代码-EZ430-rf2500 WSN

在ATmega16上的一个简单的AD转换程序-ATmega16 on at the AD of a simple conversion process

ATmega16程序，控制1602液晶，只用了六个I/O口，我仿真过的，没有错误，而且还带Pretues图。-ATmega16 procedures, controls 1602 LCD with only six I/O ports, I" ve simulation, there are no errors, but also with Pretues map.

使用软件模拟Ｉ２Ｃ与ＥＥＰＲＯＭ通讯的子程序-use of software simulation I2C EEPROM communications with the subroutine

AD977acn的应用电路及源码，使用凌阳的IDE编写的源码，提供底层的驱动。-AD977acn circuit and the application source code, the use of Sunplus IDE prepared by the source. for the bottom of the drive.

本程序功能是利用单片机控制用户板上的小键盘，将按下的键通过单片机的串口发送给PC机，在PC机串口助手显示出来。用行翻转法的方法来识别输入的键盘。 二、通过单片机将键盘按下的键在LCD上显示出来。 -This procedure is the use of single-chip control functions of the user on-board a small keyboard, the keys will be pressed through the single-chip serial port sent to the PC, the PC Serial Port assistants displayed. Line inversion method used to identify the method of keyboard input. Second, through the single-chip microcomputer keyboard keys pressed on the LCD display.

该文档是一篇毕业论文，硬件和软件齐全，历时一个月完成，非常不错-This document is a thesis, complete hardware and software, took a month to complete, very good

用于单片机32bit内的快速开方（C51）-32bit MCU for the rapid evolution (C51)

基于ARM中LPC2131芯片编写的各种uart源程序！-LPC2131 chips based on ARM in the preparation of a variety of uart source code!