这是一个测试MP3的程序，通过USB口来测试此款MP3是否出现了功能故障,或者此MP3是否是出厂状态，实现了从PC上层直接控制下层硬件的范例....

USB设备端固件程序,枚举部分是全部程序的基础和重心,只有主机对设备枚举成功后,主机才能和设备进行正常的通信 USB的枚举过程分为4个状态. 1.接入态 v主机检测到USB设备插上,击活端口,并发送复位命令(保持10ms) 2.默认态 v主机使用默认地址读取设备描述符 (GET_DESCRIPTOR) v主机分配给设备一个总在线的唯一地址 (SET_ADDRESS) 3.地址态 v主机从新的地址获取设备描述符(GET_DESCRIPTOR) v主机获取所有设备的配置描述符(GET_DESCRIPTOR) 4.配置态 v主机设置描述符(设备,配置) (SET_CONFIGURATION) v主机读取配置状态(可选) (GET_CONFIGURATION) v主机读取接口状态(可选) (GET_INTERFACE) -USB device-side firmware, enumerate all part of the foundation and focus of the procedure, only the host of equipment after the successful enumeration, the host and equipment in order to engage in normal communication USB enumeration process is divided into four status. 1. Access state v host detected USB devices plug in, hit live ports, and send the reset command (to maintain 10ms) 2. default state v Use the default address of the host to read device descriptor (GET_DESCRIPTOR) v host assigned to the equipment of a total online only Address (SET_ADDRESS) 3. A

usb programmer schematic for arm

EZ_USB 通信DLL源码，使用EZUSB公版驱动。尹邦坤设计，希望对需要的同仁又帮助。-EZ_USB communications DLL source, the use of the public version of Cypress Drive. Bang-Kun design with the hope of my colleagues also need help.

使用CY68013USB芯片开发的几个小程序，包含了断点和批量传输，通过实际硬件测试。-some P using cy68013A

我用DELPHI写的一个专为EZUSB（2131）系列芯片的DLL。有例子-I used to write an ad for EZUSB (2131) series chip DLL. Examples are

USBhost source

用HID类型开发USB设备，有兴趣的朋友可以改为VC，BCB代码。-Use HID design USB device

USB通信协议和U盘固件程序实现与调试-U disk USB communication protocols and procedures for implementation and debugging firmware

u盘复制源代码，目前支持市面上流行的所有元素，希望对大家有帮助-u disk copy source code, available on the market currently supports all the elements of pop, in the hope that everyone has to help