MSP430 MCU serial communication baud rate calculation tool

I2Cc语言程序例子,tested already.-I2Cc Language Program example, tested already.

洗衣机汇编程序，有四种洗衣模式：标准、经济、单独和脱水。-Washing machine assembler, laundry four modes: standard, economy, and dehydration alone.

DS12877A驱动程 DS12877A驱动程-DS12877A driver DS12877A driver

根据键盘的控制，移动字符串Hello或者华东师范大学,行列键盘的7用于字符串左移,8用于字符串下移，9用于字符串右移，5用于字符串上移。按键每按一下向各自的方向移动一个点阵的位置。-Under the control of the keyboard, move the string Hello, or East China Normal University, the ranks of the keyboard for the string to the left of 7, 8 for string down, 9 for string shifted to right, 5 for the string to move. Click the button for each move to their respective location of a dot matrix.

AVR_Meag8_L298控制电机的程序源码,电路原理图,M8程序使用(ICC_AVR)编译,内有说明.-AVR_Meag8_L298 control procedures for the electrical source, circuit schematics, M8 uses (ICC_AVR) compiler, which has notes.

cc1100/2500与msp430单片机的接口库函数

6段数码管分别显示，时，分，秒，四个按键，K1（P0.0），K2（P0.1）， K3（P0.2），K4（P0.3），四个按键用来调时间的，按下K1，所有位都清零显示，然后按下K2，秒在闪烁，继续按K2分闪烁，不段地按K2 秒--分--时切换着闪烁，在某位闪时按下K3相应位加一，确认调整，按K4，取消调整再按K1。在K1按下以后才有调时的功能，如果K1没有按下，按别的键没有反映。这为了在加点按键功能留着用 -6 respectively of the digital control, when, minutes and seconds, four keys, K1 (P0.0). K2 (P0.1), K3 (P0.2), K4 (width), the four keys to the transfer time, press the K1, All spaces are reset, then press K2, the scintillation seconds, according to K2 pm flickered. not according to K2 of seconds-- minutes-- when switching to flicker in certain press the flash-K3 corresponding increase in a confirmed adjustment by K4, then canceled K1 adjustment. K1 in the press will only be made after the transfer of function, if K1 pressed by other key is not reflected. This points to the function keys used Retention

msp430f169 中断方式驱动独立键盘-msp430f169 separate keyboard interrupt-driven

LT-1B开发板例子程序－ADC12_05

由于要做开发，因此很多情况下都要下载芯片资料来看，特上AD9850的datasheet供大家设计软件时使用。-As a result of the development to be done, so many cases have to download the chipset information, especially on the datasheet for the AD9850 design software you use.