ARMlpc2300技术笔记上册例程I2C操作ZLG7290

该程序能捕捉到单片机发出的正确信号，并显示出来

基于国旗升降控制系统的设计与实现，采用汇编语言设计源代码。-Based on the national flag take-off and landing control system design and realization of the design using assembly language source code.

51单片机串行口初值计算器，51单片机定时初值计算器。等多种小软件。-Initial value of 51 single-chip serial port calculator, timer initial value of 51 single-chip calculator. And many other small software.

nRF24L01 RF接收发送例子程序，采用C语言-nRF24L01 RF receiver to send examples of procedures, the use of C language

基于C51的DS1820测温的C语言源程序，有详细注释-c51 program about tempreture data acquisiton

MSP430系列单片机实用C语言程序设计-MSP430 MCU Practical C Programming Language

24C01 24C02的C51源程序|串口通信C51源程序， 未整理，但编译后的HEX代码可在WS803上直接运行。-24C01 24C02 source of C51 | Serial Communication C51 source, not collate However, the compiled code of HEX at WS803 directly run.

这是从51上移植过来T6963的源码和Proteus。用CodeVisionAVR编写的。-This is a transplant from a 51 on the T6963 and the source Proteus. Prepared with CodeVisionAVR.

NXP的mifare ultralight　数据手册, 英文版本,完成对电子标签的操作.-NXP" s data mifare ultralight manual, English version, the completion of the operation of electronic tags.

This code implements the basic functions for an I2C slave device using the SSP module. All I2C functions are handled in an ISR. Bytes written to the slave are stored in a buffer. After a number of bytes have been written, the master device can then read the bytes back from the buffer.