Sl811 increase the use of single

COP8 CPU的一个解释型BASIC源码，挺好玩的-COP8 a CPU-BASIC source explained, very good play

利用89S51单片机，通过DS18B20温度传感器测得当前的温度值，再送入4位8段数码管显示-Using 89S51 microcontroller, temperature sensor, through DS18B20 measured current temperature value, and then into four 8 digital tube display

微型打印机的驱动程序，希望对朋友们有用。-This is a driver of micro printer.Hope it is helpful to friends.

电机不转，按下启动键，电机旋转，速度为25转/分，按下加1 键，速度增加，按下减1 键，速度降低，最高速度为100 转/分，最低转带为25 转/分，按下停止键，电机停转。速度值要求在数码管上显示出来。-Motor does not turn, press the start button, motor rotation speed of 25 rev/min, press the 1 key, the speed increase by 1 press the button to lower the speed, the maximum speed of 100 r/min, with a minimum of 25 to r/min, press the stop button to stop motor. Speed value of the requirements in the digital tube display.

单片机时钟代码， 单片机时钟代码-mcu clock code

L297+L298控制步进电机，用proteus进行仿真-L297+ L298 stepper motor control, using Proteus simulation

EM78P153中文手册，EM78P153堪称最便宜的单片机，还不到二块钱一片。-EM78P153 Chinese Manual, EM78P153 rated the cheapest single-chip, less than a 2 money.

PWM逆变模型，可以观察逆变波形以及控制信号 波形，适合初学者使用-PWM inverter model, can be observed as well as the inverter waveform control signal waveform, suitable for beginners to use

1． 利用单片机内部的T0，T1计时计数器产生中断，并通过单片机最小系统按键产生外部中断，利用单片机中断系统闹钟的走时，调整及报数功能。-1. The use of single-chip within the T0, T1 timing counters generate an interrupt, and the smallest single-chip systems have external interrupt button, using single-chip system clock interrupt the travel time, and adjust the number of features reported.

Verilog实现的DDS正弦信号发生器和测频测相模块，DDS模块可产生两路频率和相位差均可预置调整的值正弦波，频率范围为20Hz-5MHz，相位范围为0°-359°，测量的数据通过引脚传输给单片机，单片机进行计算和显示。-Verilog realize the DDS sine wave signal generator and frequency measurement module test phase, DDS module can generate both frequency and phase difference can be preset to adjust the value of sine wave, frequency range of 20Hz-5MHz, phase range of 0 °-359 ° , measurement data and transmit them to the single-chip pin, single-chip microcomputer to calculate and display.