usb hid devices on the site from abroad

USB的驱动程序，源码-USB driver, the source

This directory contains the 8051 firmware Vend_Ax source code for the Anchor Chips EZ-USB chip.

基于fpga的usb实现，包含简介，程序，原理图，与大家分享！-USB implement based on FPGA, including program and schematic circuit diagram. Share with all you.

全面介绍USB_F320的实用文章USB_F320-USB introduced a comprehensive article

usb接口的硬件设计参考-usb interface hardware reference design

这个程序用180行C代码就能够读取FAT16文件系统U盘的根目录,可以看到根目录下的文件名,并可显示首文件内容,不过,该程序很不严谨,也没有任何错误处理,对U盘兼容性较差,只是用于简单试验,作为参考.这个程序可以支持WINDOWS按FAT16格式化的U盘,因为程序精简,所以只兼容超过50%以上的U盘品牌,如果换成CH375A芯片则兼容性可提高到85%,当然,如果使用WCH公司的子程序库或者正式版本的C源程序兼容性更好-this procedure with 180 OK C code can read FAT16 file system drives the root directory, we can see the root directory under the file name, would show the first document, but the very stringent procedures, and there is no error handling, the U-poor compatibility, but for the simple the pilot, as a reference. this procedure can be supported by Windows FAT16 formatted U disk, because the procedure is streamlined and therefore only compatible with more than 50% of the U-brand, if chips were replaced CH375A compatibility can be increased to 85%, if the company"s use of WCH Subroutine Library or an official version of the C source better compatibility

用CY7C630芯片做USB转串口的汇编原程序,里面有编译生成的hex文件.写入芯片就可使用.最高波特率为24-do with CY7C630 chip USB to Serial compilation of the original procedure, which has compiled documents generated hex. The chips can be used. The highest baud rate for 24

CYPRESS CY7C69013A使用的驱动！-CYPRESS CY7C69013A driver to use!

使用68013的测试程序，包含68013固件程序（采用slave FIFO bulk同步读写，EP2 OUT，EP6 IN），驱动，PC端测试用程序。CPLD的VHDL代码-Test procedures for the use of 68,013, including 68,013 firmware (using the synchronous slave FIFO bulk read and write, EP2 OUT, EP6 IN), driver, PC-side test procedures. VHDL code of CPLD

usb接口的jtagice的电路板图-jtagice usb interface circuit board map