24C01的汇编驱动程序。直接解压。 有注释

用LPC764制作的摩托车电喷系统程序源码-LPC764 produced motorcycle with EFI system program source

MSP430 C 例程_编译器为IAR embedded workbench,如要更多资料请联系我-MSP430 C compiler routines _ for IAR embedded workbench, if more information please contact me

PIC12F629写的另一个LED变化程序(慢慢从暗到最亮,用时三秒-->维持最亮四秒-->慢慢从最亮变暗,用时三秒-->维持暗灭两秒, 周而复始.-PIC12F629 write another LED changes (slowly from the dark into the light, in the opening three seconds--

本程序是用于高速冲床上的送料控制程序，一个较为简单的89C51中断、定时计数器应用程序，已经调试成功，今天为大家出点力，也希望能在以后的学习中能得到大家的帮助。-This procedure is used for high-speed red bed feed control procedures, a relatively simple 89C51 interrupt, timer counter application has debugging success for the U.S. today, a little effort, but also hope to study in the future everyone will be help.

The Burr-Brown s ADS1252 support for PIC16 microcontroller

c51 led菜单 程序 功能 上下选择菜单-c51 led program features up and down menu selection menu

三相电机调速程序，集成了AD，系统初始化，结构化。可以作为电机控制的参考-three-phase motor procedures, the AD integration, system initialization, structured. As motor control reference

Basic coding for Digital communication

msp430usart实验程序采用IAR嵌入式工作台软件开发

,片选接到p1.5 复位端 p1.4 中断端接到 int0 82c250工作在斜率模式下 ，RS 接51k电阻到地。 2，SJA1000与82C250的接口，逻辑上为SJA1000输出0（显性位），表现为低点平输出给82C250，则82C250输出 差分的低电平。SJA1000输出1（隐性位），表现为高电平或悬空输出给82C250，则82C250输出悬空状态。 3,周立功的中SJA_BCANCONF.ASM中对输出控制寄存器 的TX0的输出 极性的位的定义不对。 还有里面定义有接收错误标志码，不知道何时用。-, The election received a P1.5-chip client p1.4 interrupt reset int0 82c250 client received in the slope mode, RS then 51k resistor to ground. 2, SJA1000 with the 82C250 interface, logic for SJA1000 Output 0 (dominant bit), showing low level output to the 82C250, while the low-level differential output 82C250. SJA1000 Output 1 (recessive), and the performance of the output is high or left vacant to the 82C250, the vacant state 82C250 output. 3, Zhou Ligong in the SJA_BCANCONF.ASM of output control register TX0 output polarity bit the definition of wrong. Inside the definition also has to receive error flag code, I do not know when to use.