1602LCD显示c51

GCC的SD卡完整程序！可根据自己需要更改！-GCC complete the procedure of SD card! May need to change according to their own!

4*4扫描键盘,通过键值通过4个数码管显示出来.-4* 4 Scanning keyboard, through key through four digital tube display.

四位数码管显示 没1分钟进1位 是通过最原始的51单片机来实现的 -Four digital display not one minute is one of 51 through the most primitive single-chip microcomputer to realize the

单相电机变频驱动原码,采用DISPIC30芯片-Single-phase motor inverter drive the original code, the use of chip DISPIC30

avr单片机学习的 希望对大家有用 -avr Singlechip everyone would like to learn useful

本程序使用AduC812单片机,实现从键盘读取数字,并用LED指示灯显示按键所在行列数-the procedures used Aduc812 Microcontroller microcontroller, read from a digital keyboard and LED indicator shows where the ranks of a few buttons

本方法的基本思想就是利用单片机具有的PWM端口，在不改变PWM方波周期的前提下，通过软件的方法调整单片机的PWM控制寄存器来调整PWM的占空比，从而控制充电电流-The basic idea of this method is the use of microcontroller has the PWM ports, without changing the PWM square wave cycle, under the premise of the method to adjust by software MCU PWM control registers to adjust the PWM duty cycle and thus control the charge current

schematic diagram of dot matrix 8x8

在51单片机系统中实现CRC校验的方法，以及CRC校验的原理-51 single-chip microcomputer system in the realization of the CRC checksum, as well as the principles of CRC Checksum

一个电器智能控制开关的源程序，可作为智能家居系统中的一个模块使用，与上位机相连，接收上位机的指令并进行开关动作，可查询状态-An intelligent control switch electrical source, can be used as smart home system, a module to use, with the host computer connected to host computer receives the instructions and make switching action, you can check the status