s3c2410ucos移植实验成功移植到中心2410…

93c46读写程序-93c46 literacy procedures

语音通用程序，适用于凌阳SPCE061单片机。-voice common procedures applicable to Sunplus SPCE061 SCM.

linux下基于9260的应用例程：udp-application example(linux) based on atmel9260： udp

直流电机驱动芯片采用Ｌ２９８．支流电机驱动就是利用ＰＷＭ脉宽控制Ｌ２９８电流输出大小，从而达到控制电机的目的-Motor Driver IC using L298. Tributaries is the use of motor-driven PWM pulse width control L298 current output size, so as to achieve the purpose of the electrical control

2410 boot

ucos 移植实验成功把ucos移植到2410上建立十个任务，每个任务不停地往串口上打印自己的任务号-CENTER transplantation experiments successfully transplanted to CENTER 2410 on the establishment of 10 tasks, each task to keep serial printing its own mandate,

报警产生器,有详细的C语言代码，还有详细的电图，可通过PROTEUS仿真。-Alarm Generator, has a detailed C language code, there is a detailed electrical diagram, through the PROTEUS simulation.

通过按键实现继电器的开和关并在数码管上显示ON和OFF 

AT91RM9200的USB host测试代码，仅供学习（ADS1.2）-AT91RM9200 USB host test code, only to learn (ADS1.2)

The objective is to set up SPI communication between VTI Technologies digital pressure sensor component and an MCU of an application device ATMEGA16L. In this code example: ?The MCU is configured ?SCP1000-D01 is initialized and configured ?The high resolution measurement mode is activated ?Temperature and pressure information is read always when the DRDY pin is in high state Please refer to the document "SCP1000 Product Family Specification 8260800" for further information on SCP1000 register addressing and SPI communication. This document applies to the SCP1000-D01.-The objective is to set up SPI communication between VTI Technologies digital pressure sensor component and an MCU of an application device ATMEGA16L. In this code example: ?The MCU is configured ?SCP1000-D01 is initialized and configured ?The high resolution measurement mode is activated ?Temperature and pressure information is read always when the DRDY pin is in high state Please refer to the