Matlab编写的H264编解码代码

this is a senoising algorithm.

The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):

本征正交模态分解法,用于多维随机场特征模态提取，得到特征值及特征向量(proper orthogonal decompositioin)

MIMO未知输入观测器的matlab仿真 simulink方法实现(MIMO unknown input observer)

图像处理中常用的的标准图像，已经分类，包括PNG、BMP、TIFF、JPG等，未进行二次处理(The image processing used in the standard image has been classified, including PNG, BMP, TIFF, JPG, not second)

simulation file in matlab simulink

通过matlab程序编辑雅可比算法的源代码，实现雅可比算法解决数学问题(Matlab program by editing the source code for Jacobi algorithm to achieve the Jacobi algorithm to solve mathematical problems)

利用MATLAB的simulink进行的海上风力机的三维仿真(Three-dimensional simulation of MATLAB simulink conducted offshore wind turbine)

In previous work, we presented GMTI detection and geo-location results from the AFRL Gotcha challenge data set, which was collected using a 3-channel, X-band, circular SAR system. These results were compared against GPS truth for a scripted vehicle target. The algorithm used for this analysis is known as ATI/DPCA, which is a hybrid of alongtrack interferometry (ATI) and the displaced phase center antenna (DPCA) technique. In the present paper the use of ATI/DPCA is extended in order to detect and geo-locate all observable moving targets in the Gotcha challenge data, including both the scripted movers and targets of opportunity. In addition, a computationally efficient SAR imaging technique is presented, appropriate for short integration times, which is used for computing an image of the scene of interest using the same pulses of data used for the GMTI processing. The GMTI detections are then overlaid on the SAR image to produce a simultaneous SAR/GMTI map.

matlab指令大全 含matlab常用函数 绝对的好(matlab command matlab with Daquan absolute good common function)