键盘开发源码，通过PS/2键盘用于对单片机的操作，其中包括了单片机的程序代码等等。...

单片机实现4×4键盘及8位数码管显示构成的电子密码锁，带有keil程序以及protuos的模拟电路。-SCM 4 × 4 keyboard and 8-bit digital tube display constitutes an electronic code lock with keil procedures and protuos of analog circuits.

这是一个用单片机与PC进行232通讯来采集模拟信号的装置-This is a used PC for 232 single-chip microcomputer with communications to the analog signal acquisition device

适合开发板EasyARM2200、SmartARM2200、MagicARM2200和MagicARM2200-S，可将程序下载到flash-Suitable development board EasyARM2200, SmartARM2200, MagicARM2200 and MagicARM2200-S, the procedure can be downloaded to flash

uclinux的jffs2文件系统-Basis of Uclinux jffs2 file system

温度测量的模拟信号发生 基本原理图，可运用于各种温度传感器-Temperature measurement of the basic principles of analog signal map, can be applied in a variety of temperature sensor

ARM平台下的数字音频AGC处理源代码 采用EP9302,对数字音频进行AGC处理 -ARM platform digital audio AGC deal with the source code using EP9302, to deal with digital audio for AGC

基于ATMEGA16的时钟芯片原代码，拿过来就 可以用-Based on ATmega16 chip clock source code, get back on the can

这是一个用AT89C51制作的2.4G频率计的源程序-this is a 2.4GHz frequency tester s program for AT89C51

摘要：该声音导引系统由声音导引主控系统和小车控制系统两部分组成。声音导引主控系统主要由主控MCU、声音接收部分、无线发射模块组成。小车控制系统主要由MCU、固化模块NEC、电机驱动部分、声光部分及无线接收模块组成。该系统的最大特点在于其软件设计使用层次化、模块化设计方法，系统低功耗，性价比低。经调试和测试，系统各项性能参数达到设计指标。 关键词：声音导引、无线收发、声源移动、M 智能语音小车-Abstract: The guidance system consists of the sound systems and car audio guidance master control system composed of two parts. Sound-guided mainly by the main control system master MCU, the sound receiving part, the wireless transmitter module component. Vehicle control system mainly consists of MCU, curing module NEC, motor drive parts, sound and light parts and the wireless receiver module. The most prominent feature of the system software designed for use in its hierarchical, modular design approach, the system low-power, low cost. The debugging and testing, system performance parameters to achieve the design target. Key words: sound guidance, wireless transceiver, a sound source movement, MCU, NEC, motor drive

Linux内核裁减 （1）安装module-init-tools-3.0.tar.gz:  (2)安装modutils-2.4.25-8.9.i386.rpm:  （3）安装新内核:  请点击左侧文件开始预览 ！预览只提供20%的代码片段，完整代码需下载后查看 加载中 侵权举报