基于STR710 spi接口的MMC/SD卡(SPI模式)驱动程序-STR710 spi interface based on the MMC/SD card (SPI mode) driver

一个ARM7定时器程序，程序采用的程序员可以了解ARM7编程方法，程序启动，地址映射等基本概念和方法

基于ARM7的开发板的存储器重映射驱动程序，文件里有程序的详细注释，对与在此基础之上的二次开发非常方便-based on the ARM7 development board memory re-mapping driver, the documents detailed procedures Notes right and the basis of this second development is very convenient

ARM7-LPC2148的外部中断源码-ARM7-LPC2148 external interrupt source

ARM Cortex-M3 系列处理器 的实验代码，内容很全，涉及片内和外围所有部件编程。（Keil环境） -ARM Cortex-M3 family of processors experimental code, content is very wide, involving all the components and peripherals on-chip programming. (Keil environment)

8051 programmer, to program any ISP microcontroller, for example Atmel AT89S51, AT89S52, etc

三星的NAND-FLASH，有1G字节的存储空间。-Samsung

基于lpc2214的矩阵键盘扫描程序，5*5的键盘，c语言程序 -LPC2214-based matrix keyboard scanner, 5* 5 keyboard, c language program

采集AIN0和AIN1的信号，通过可调电阻，使输入的模拟信号发生改变，来进行A/D转换。为保证数据的准确性，通常采集10次以上，在求平均值。A/D转换器采集AIN0和AIN1的信号,并显示出来。-AIN1 acquisition and AIN0 signal, through an adjustable resistor, so that the analog signal input to change, to carry out A/D conversion. In order to ensure the accuracy of the data is usually collected 10 times more than the average in the order. A/D converter and acquisition AIN0 signals AIN1 and displayed.

针对传统电液比例控制系统的性能较差，本文提出了一种基于ARM和uC/OS-II的电液比例控制系统的设计，并详细介绍了以ARM内核微控制器LPC2292和电机驱动芯片LMD18200为核心的硬件电路，以及嵌入式操作系统μC/OS-II在ARM7上的实现。-Traditional electro-hydraulic proportional control system for poor performance, this paper presents an approach based on ARM and uC/OS-II of the electro-hydraulic proportional control system design and described in detail in order to ARM core LPC2292 microcontroller and motor driver chip LMD18200 at the core of the hardware circuit, as well as the embedded operating system μC/OS-II in the realization of ARM7.