南京沁恒公司CH375标准版的C语言源程序

232同485转换的pcb图，有需要的只要稍加修改一下就可以了-232 with 485 conversion pcb diagram, there is a need for as long as a little tinkering can be a

51单片机的多机串口互连 通信函数，提供缓冲区，通过P2口的输入决定从机号。在STC89C52，AT89S52上通过。-51 Single-chip interconnection of multi-machine serial communications function, providing a buffer, through the input port P2 from the machine its decision. In STC89C52, AT89S52 adopted.

由SPCE061A控制的74HC164的驱动程序,一般用于串转并-by the 74HC164 SPCE061A control of the driver, the general and for Series switch

motorola 1.4" CSTN LCD test program. Drive IC: SSD17-1.4 "CSTN LCD test program. Drive IC : SSD17

STC89C52脉宽调制

利用51单片机控制红外遥控的发射部分的程序，该程序在51单片机的基础上，采用一定的协议，进行编码、调制和发送等，具有很实用的价值。-51 SCM control the use of infrared remote control transmitter of the program, the program in MCS-51, based on the use of certain agreements, coding, modulation and delivery and so on, have a very practical value.

定时器中断实验代码， 定时器3进行0.1秒定时，每0.5秒改变一次P2,P3口的值以产生走马灯效果。-timer interruption experimental code, three timers for 0.1 seconds regularly, every 0.5 seconds to change a P2, P3 to the values I have merry-go-round effect.

MCS51单片机接受EV1527数据的汇编程序-MCS51 accept EV1527 data compilation process

单片机系统中的汉字显示 　　 摘要： 需要显示的汉字较多时，单片机系统中的汉字编码非常繁琐。本文介绍一种直接利用PC机的汉字内码作为单片机系统的汉字编码，以简化系统的设计。-SCM system of Chinese character display Abstract : The need to show the Chinese characters more, the SCM system of Chinese character coding very cumbersome. This paper presents a direct use of the PC as the Chinese character coding SCM Chinese character coding system to simplify system design.