sql表的制作过程演示

动平衡相关算法 本程序介绍了一些与旋转机械动平衡相关方面的算法 -balancing algorithms on the procedures with a number of rotating machinery related to the balancing algorithm

详细完整的DOS/BIOS中断功能大全，英文版.-detailed integrity of the DOS/BIOS interrupts Daquan and English.

这个函数返回n点2dw波段的傅里叶变换的DFT样本序列。通常情况下，以插值点的方式进行放大。-This function returns N point DFT samples of 2dw band of Fourier transform of a sequence. Typically, fft() returns N samples of Fourier transform ranging from 0 to 2pi. This function takes the N-point DFT samples and returns N-point samples corresponding to frequency band wc-dw to wc+dw.

微机原理课程设计整点报时系统，武汉理工大学开发的试验箱！-Microcomputer Principles of curriculum design, the whole point timekeeping system, Wuhan University of Technology developed by Chambers!

在机动目标跟踪中，机动目标模型是机动目标跟踪的基本要素之一，一般希望机动目标模型能准确表征目标机动时的各种运动状态。比较常用的模型有匀速运动(CV)模型、匀加速运动(CA) 模型、时间相关模型（Singer）和机动目标“当前”统计模型。上述模型均采用机动频率表征目标的机动情况。在应用当中，通常采用固定的机动频率，这就表示机动目标的机动时间是一定的，而实际上机动目标的机动时间是不断变化的，也就是说机动频率是不断变化的，采用固定机动频率必然会带来误差。采样周期在0.5―2S时，机动频率越小跟踪精度越高[1]，但机动频率仍然是固定值。本文提出的基于神经网络的机动频率自适应调整方法可以使机动频率随机动而变化，从而提高状态估计的准确性，提高跟踪精度。本文将小波神经网络用于机动目标跟踪中机动频率的自适应调整，该算法对机动目标“当前”统计模型中的机动频率进行实时修改, 从而自适应的改变机动频率,使跟踪算法与目标的真实状态更接近。该算法采用小波神经网络的离线训练，实时性好。-The maneuver of the maneuvering target is uncertain. The maneuvering frequency is constantly changeable, but traditionally it is beforehand determined as a constant based on the target state estimation in the state model of the maneuvering target. The maneuver of the maneuvering target makes the kinematics equation of the target model mismatch with the practical motion model and the tracking error will be increased. Based on the advantages of the self-learning, the rapid convergence rate and the nonlinear approximation ability of the wavelet neural network,

支持向量聚类的保存结果的源程序很小　不大-support vector clustering results of the program to preserve small little

用JBUILDER和SQL2-with JBUILDER and SQL2

Avalon Interface Specification,The Avalon interface specification is designed to accommodate peripheral development for the system-on-a-programmable-chip (SOPC) environment. The specification provides peripheral designers with a basis for describing the address-based read/write interface found on master and slave peripherals, such as microprocessors, memory, UART, timer, etc.

利用类及派生类在屏幕上输出英语问好提示，其输出结果如下图所示。 -category and the use of derived classes in English output on the screen greets suggest that the output results as shown in the diagram below.

DSP算法标准1。可方便自己快速找到所需要的TI算法文档-a DSP algorithm standard. Facilitate their rapid find the necessary documentation TI algorithm