ARM2131的程序模块，为新学习ＡＲＭ新程序学习使用；

1602液晶时钟，带仿真-1602 LCD clock, with simulation

CAN上位机通讯程序vb与单片机通信时用的上位机程序 -CAN PC communication program vb and MCU communication procedures used in PC

430成都技术培训会代码，使用IAR-4.10打开。-430 technical training in Chengdu will be the code, the use of IAR-4.10 open.

LT_1B msp430开发板例子程序－TB7

风机控制器智能程序2,请大家自己使用,千万不外传!-Intelligent fan controller procedures for two, let us own use, do not Gaiden!

采用定时器中断的方法，设计一个一天24小时进制的实时时钟；用6个发光二极管分别显示时、分、秒的记时； 能进行整点报时。可以从键盘中预置、修改时钟值。含有硬件设计图-timer interruption using the method to design a band 24 hours a day in real-time clock; With six light-emitting diodes showed the hours, minutes, and seconds to the entry; Can the entire point timekeeping. Which can be preset from the keyboard, the revised value of the clock. Containing the hardware design

开机自启动程序，很好很强大的。每次开机都能自己启动此程序。-Boot from the startup procedure, very good very strong. Each boot can start this process themselves.

状态1：正常时，8个LED发光二极管（彩灯）循环点亮。 • 状态2：有报警时，蜂鸣器发出报警声（用P3.3接一个按键，模拟产生报警信号。当开关合上，发生报警；当开关断开，报警停止。用P3.7输出音频信号驱动扬声器，作为报警信号），同时8个LED发光二极管（彩灯）闪烁。 P3.2接一个按键，用于消除报警-Status 1: normal, eight LED light-emitting diodes (lantern) light cycle.

AVR单片机浮点数、串口波特率、定时器参数计算器，很不错的小软件！-AVR microcontroller floating-point, serial baud rate, timer parameter calculators, a very nice small piece of software!

单片机基础，经典,初学必备-microcontroller based, classic, beginner essential