通过XINTF 接口实现网页

本例程说明了TMS320F28XX的CAN 总线的操作方法，供大家共享-This routine illustrates the CAN bus TMS320F28XX method of operation for the U.S. share

基于TI公司的5509平台的FLASH读写程序-Based on TI

《数字信号处理-理论、算法与实现》（第二版）源代码-err

SeedDM642平台，h263_loop为H263算法程序，包括了H263算法的压缩与解压-SeedDM642 platform, h263_loop for H263 algorithm procedures, including the H263 compression and decompression algorithms

数字I/O实验主要完成的功能： 在此实验中，SEED-DEC5416 首选进行初始化，包括对外设 UART、本身频率的设定及一些状态区的初始化。然后等待 SEED-MMI5402 发送命令；SEED－DEC5416 响应交通灯自动模式、交通灯手动手动模式、交通灯东西通、交通灯南北通、及交通灯的禁行与夜间模式的操作命令。同时还响应，对 SEED-DEC5416 的复位及两个单元之间的通讯故障。 -Digital I/O completion of the experiment the main features: In this experiment, SEED-DEC5416 preferred to initialize, including peripherals UART, their frequency settings and some of the initialization state of the district. SEED-MMI5402 and then wait to send commands SEED-DEC5416 automatic mode in response to traffic lights, traffic lights manual manual mode, the traffic light east-west pass, pass traffic lights north and south, and traffic lights at night and cut-line mode command. At the same time, also responded to the SEED-DEC5416 reset and communication between two modules fault.

很好的dsp开发程序，ＳＰＩ程序，ＣＣＳ３.３下调试通过-Dsp good development process, SPI procedures, CCS3.3 debugging through

c程序100例,里面的内容比较基本，每个程序基本都可以编译运行，是不错的资料。-100 cases, the contents inside more basic, basic procedures of each compiler can run, good information.

TI DSP最小系统原理图，是protel文档，直接可运用，相当好-TI DSP minimum system schematic is Protel documents, can be used directly, quite good

GENERIC PROGRAM FOR A FAST LOOPED-CODE RADIX-2 DIT FFT-GENERIC PROGRAM FOR A FAST LOOPED-CODE RAD IX-2 DIT FFT

DSP基于ccs2.0 的语言程序，主要是在定时器到来时进行ad采样再da输出-ccs2.0 the DSP-based language program, mainly in the coming timer when ad sampling da output again