DSP快速pwm

用C语言编写的FFT，可以在DSP通过运行。 -C language FFT can be run through the DSP.

DSP的T6963液晶测试程序,数据端口8000H，代码端口8001H-DSP-T6963 LCD test procedures, data ports 8000H, code ports 8001H

DSP TMS320C6713 ESAM程序，希望对大家有用。-DSP TMS320C6713 ESAM procedures useful to everyone.

通过对ADSP-BF53x 处理器EBIU 端口编程控制IDE 接口对硬盘的读写。附带详细文档。 DM-EDU-SSKBF53x 开发板一套（DM-KIT-CBBF53x 模块，DM-KIT-EXBSSK-BF5xx 模块)，DM-TOOLSUSBICE2.0 仿真器一套，带有电源的标准40PIN 接口硬盘-Through the ADSP-BF53x processor EBIU programming control port IDE interface hard disk read and write. Comes with detailed documentation. DM-EDU-SSKBF53x development board set (DM-KIT-CBBF53x module, DM-KIT-EXBSSK-BF5xx module), DM-TOOLSUSBICE2.0 emulator set with a standard 40PIN Power Supply Interface Hard Disk

TI CCS2.1 task 信号量之间相互操作的样板程序,文件包是一个完整的工程.-volume signal operation between the model procedures, documentation package is a complete project.

DSP编程CMD文件的详细说明和指导也很有用！

SEED_DEC5416的FLASH的boot程序源码-SEED_DEC5416 the FLASH source of the boot process

在BBS水木清华站：精华区汇集的关于DSP的相关经典帖子。其中设计厂商信息、入门知识、仿真器、软件工具、硬件开发、软件开发、外围器件、调试经验等。-In the BBS SMTH: Digest brings together the classic on the DSP-related posts. In which designers information, entry knowledge, simulator, software tools, hardware development, software development, peripheral devices, debugging experience.

详细说明：这是一个GPIO的TI DSP2812应用程序：天棚程序允许8个Led灯，然后轮流以1秒的间隔闪烁，附录a完整的背书程序

TCPIP移植到DSP上的工程源码，包括与RTL8019以太网接口的程序。-TCPIP transplanted to DSP on the project source code, including those related to RTL8019 Ethernet interface procedures.