ARM cortex

Hermit-at-1.1.3,一款bootloader，不想uboot那样大，比较好用，可以作为学习bootloader的一个不错的参考-Hermit-at-1.1.3, a bootloader, as big as uboot do not want to compare the ease of use, the bootloader can be used as learning a good reference

用于arm2410开发系统，使用时间中断产生脉冲信号，可测试系统可测试的最短信号-for arm2410 development system, the use of time interrupt pulse signal test system may be the shortest test signal

帮助理解ARM中Bootloader的启动过程，能理解中断物理地址。了解程序的开发过程，加深对嵌入式程序的理解

分析了动态称重的干扰问题，针对高速运行的动态称重，提出了AR回归模型算法，研究了自动分选的机械机构构造，以及链式称重的难点和重点

LPC2200系列的RAM测试程序，已改进，当RAM有故障会，急声报警；正常这按心跳频率发声。 改地址也可以用来有效测试FLASH-err

一个基于arm的can通讯的源代码 目前还没有使用任何rtos 可以很方便的嵌入到任何rtos中去-one can Based on the communications arm of the source code has not used any Byelorussian can easily embedded into any of the Byelorussian go

流明诺瑞ARM1138开发板GPIO程序-luminary ARM1138 development board GPIO program

his project was built and tested with WinAVR-20060125. Make sure the MCU target define in the Makefiles corresponds to the AVR you are using!! To build the code, just install WinAVR and run "make" from the console in echomaster and echoslave subdirs. "make program" will program the device if you have a AVRISP attached. Remember to set the AVR device to at least 8MHz. The AVR may use the programmable clock from MC1319x, just remember to check if the MC1319x and SPI communication is working FIRST! Otherwise you wont get any clock signal to the AVR and then you can t program it or reset the fuses! The MC1319x has default clock output of 32kHz so you will have to set your programmer to a very low frequency (

单片机C语言100例源代码基于PIC单片机C语言100例源代码基于PIC单片机C语言100例源代码基于PIC单片机C语言100例源代码基于PIC

frequency allocation program which can be usefull for the telecommunication engineers