p2p穿透源码

此程序是一个直接序列扩频与跳频混合的扩频通信系统的仿真，扩频码用的是线性移位寄存器产生的m序列，跳频的跳点数为4。

通过打印口（rs232)测试pic编程器的小程序。-This is a small program to test pic progamme implements by LPT(rs232).

关于ZIGBEE技术的实用手册，对于需要了解ZIGBEE技术和利用ZIGBEE技术开发的人很有用处-ZIGBEE technology on a practical manual for the need to understand technology and use of ZIGBEE technology development ZIGBEE very useful person

自己初学写的有关网络传输数据的小程序，请大家多多指教-learning to write their own network transmission of the data of small procedures, please exhibitions

此文档是介绍孤子在饱和介质中传输的matlab仿真过程，孤子仿真网上有很多文章，可是均不带源码，恰巧本人编了些就都传上了，希望对各位有用。-Introduction This document is at saturation soliton transmission medium matlab simulation process, there is a lot of soliton simulation online article, but not with source code, I made something happen on both a mass on the hope that useful to you.

一个串口监视程序 com通讯可使用 适合高级以下串口编程者使用-Com a serial communications surveillance program can be used for high-level programming using the following serial

c++并口测试程序源码,还不错，适于初学者参考。-c++ parallel test program source code, but also good, suitable for advanced users.

应用背景This document describes how to set up a 6x6 multiple input, multiple output (MIMO) system using NI LabVIEW software and NI USRP™ (Universal Software Radio Peripheral) hardware. After a brief discussion of MIMO, the paper examines the hardware and software based on LabVIEW for a 6x6 MIMO-OFDM system using 4-QAM as modulation scheme. The system presented here is also capable of working as a 2x2 MIMO and 4x4 MIMO system with appropriate parameter configuration.关键技术With MIMO, you can increase wireless system performance without increasing power consumption. It is based on the idea that when using multiple antennas, the transmitted signal progresses through different wireless channels, from the transmitter antennas to the receive antennas, to

#include "config.h" INT8U RBUF; INT8U TDAT,RDAT; INT8U TCNT,RCNT; INT8U TBIT,RBIT; BOOLEAN TING,RING; BOOLEAN TEND,REND; INT8U uc_rxdIndex,uc_rxdDealIndex; INT8U uc_uartBuf[UART_BUF_LEN]; INT8U uc_uartRecFifoLen; /* 接收FIFO中的数目 */ BOOLEAN b_uartRecFifoFlag; INT16U us_allSendCnt; INT8U uc_sendCnt; //INT8U * pSendBuf; INT8U * p_pSendBuf[P_SEND_BUF_LEN]; /* 要发送的数据的指针 */ INT8U uc_pSendBufLen[P_SEND_BUF_LEN]; /* 每个指针包含的数据长度 */ INT8U uc_pSendBufIndex; INT8U uc_pSendBufDealIndex;

windows 平台程序，网络程序代码，vc++6.0-windows platform program, the network code, vc++ 6.0