51例有很多很好的例子，原来的原代码…

LT_1B msp430开发板例子程序－TA_16

此程序实现无线信标定位，GPS产生的信号经过（7，4）汉明码编码后发送，接收端解码得到发送端坐标。程序分为发射和接收2部分，在Keil C下编译实现。-This procedure positioning wireless beacons, GPS signal generated by (7,4) hamming code is encoded to send, receive decoding client coordinates to be the sending end. Transmitting and receiving procedures are divided into 2 parts of the Keil C compiler under implementation.

包括读写器源代码，专为研究RFID技术学习之用-Philips makes no warranty, expressed, implied or statutory, including but * not limited to any implied warranty of merchantability or fitness for any *particular purpose, or that the use will not infringe any third party patent,* copyright or trademark. Philips must not be liable for any loss or damage* arising from its use.

430成都技术培训会代码，使用IAR-4.10打开。-430 technical training in Chengdu will be the code, the use of IAR-4.10 open.

这是philips 公司的fm 芯片tea5767的驱动程序-This is the Philips chip tea5767 fm driver

此程序是用于单片机e2rom读写的程序。-The firmware of the USBisp is easy to upgrade. A software upgrade works also via the USB interface. The package contains a STK500 compatible bootloader so you can use avrdude to update the firmware. There are 7k of flash left in the ATMega8

用C语言实现51单片机232串口通信程序，已经调试好了-51 using C language to achieve single-chip serial communication program 232 has better debugging

高速PCB设计指南,一本很有用的画线路板的书.-High-speed PCB design guidelines, a very useful circuit board painting book.

用SD模式读SD卡的代码,写功能尚未实现,希望能给您一点帮助!-SD mode with SD card code reading and writing function has not yet been achieved, I hope to give you a little help!

ateml 10位AD 通用程序-ateml 10 AD common procedures