基于ARM平台的以太网通信，选用的网卡芯片是DM9000，一款周立工提供的芯片，已调试成功。...

描述了如何配置stm32f10x的ADC控制寄存器，ADC1被配置为有顺序地转换第14与17通道的模拟输入量，ADC2被配置为有顺序地转换第10与11通道的模拟输入量。-This example describes how to use ADC1 and ADC2 in regular simultaneous dual mode. ADC1 is configured to convert channel14 and channel17 regular channel continuously. ADC2 is configured to convert channel10 and channel11 regular channel continuously.

WebServer on LPC2364

ARM lpc2129 串口传输数据c和汇编程序-ARM lpc2129 serial transmission of data and compilation procedures c

针对传统电液比例控制系统的性能较差，本文提出了一种基于ARM和uC/OS-II的电液比例控制系统的设计，并详细介绍了以ARM内核微控制器LPC2292和电机驱动芯片LMD18200为核心的硬件电路，以及嵌入式操作系统μC/OS-II在ARM7上的实现。-Traditional electro-hydraulic proportional control system for poor performance, this paper presents an approach based on ARM and uC/OS-II of the electro-hydraulic proportional control system design and described in detail in order to ARM core LPC2292 microcontroller and motor driver chip LMD18200 at the core of the hardware circuit, as well as the embedded operating system μC/OS-II in the realization of ARM7.

改变一个LED STM32卡的状态这一

ARMLPC214x/LPC213x程序例程-err

At91rm9200EEPROM代码（Ｃ）-At91rm9200EEPROM code (C)

ARM7S3C44B0开发板BIOS-ARM7S3C44B0 development board BIOS

K9F1208 在STR710处理器上的驱动源代码-STR710 processor K9F1208 in the driver source code

用于读取和写入 eeprom （flash 银行） 在 stm 32 f 407 测试的 f407ig 在这一阶段微控制器时钟设置已经配置， 这是通过 SystemInit() 函数，从启动时调用 文件 (startup_stm32f4xx.s) 前分支到主应用程序。 要重新配置的 SystemInit() 函数的默认设置，请参阅 system_stm32f4xx.c 文件