atmega16L input capture classic trials have been validated

用8051单片机 DS18B20显示是用LED,单片机用AT89S52. 做的温度控制系统-With the 8051 DS18B20 display is used LED, Microcontroller with AT89S52. To do temperature control system

这是sd/mmc卡程序地而部分内容，后面还有！-This is the sd/mmc card program and part of the contents in the back there!

ATMEL 89c51sndc mp3外接硬盘源码-mp3 ecpand hdd drive! 51 source ,mcu is atmel 89c51

该文件提供51c程序点阵led显示模块，可以运行在arm平台-51C of the document provides procedures led dot matrix display module can be run on arm platform

8x8矩阵示例

利用脉冲控制伺服电机运转，伺服电机频率通过改变定时器初值来控制-The use of pulsed operation of servo motor control, servo motors by changing the timer frequency to control the initial value

TG19264（点阵式无字库192*64）LED驱动，可在任列和行显示，可反白显示.-TG19264 (dot-matrix font free 192* 64) LED driver can be in any column and row shows that can be highlighted.

用L298作为驱动器，控制两相混合式步进电机。 按键从上至下分别为减速，加速，正转，反转，停止。 具体参数还没有设定过。速度有些慢，加速按2下有效，然后就不能再快了。 转速输出是按照最小系统版的数码管写的。电路图里太麻烦就没画了。-Using L298 as the drive to control two-phase hybrid stepping motor. Buttons from top to bottom respectively, deceleration, acceleration, are being transferred, reverse, stop. Specific parameters have not yet been set. Some of the slow speed, speed up by 2, effectively, and then can not be faster. Speed output is in accordance with the minimum system version of the digital tube wrote. Circuit where not too much trouble drew.

MCS51外部中断1和定时器T0的应用，外部中断1连接一个按键，通过调节按键改变定时器的值，定时器输出连接一个蜂鸣器-MCS51 and one external interrupt timer T0 applications, external interrupt 1 to connect a button, through the adjustment button to change the timer value, the timer output to connect a buzzer

Ad_da转换，用于单片机程序开发。ARM-Ad_da conversion for microcontroller programming. ARM